Hi James,
excellent work - hope you're pleased with the result. If you're anything like me you'll be glad the job's over but happy with all the new things you now know :-)
Cheers, Pete
Hi James,
excellent work - hope you're pleased with the result. If you're anything like me you'll be glad the job's over but happy with all the new things you now know :-)
Cheers, Pete
Hiya,
those look like Pegasus wheels, and they look genuine to my untrained eye. Are they? If they're genuine they're 8J wide, if not they'll be 7.5J
Either way, I found it a bit too much for...
Hi,
don't know about the alarm I'm afraid.
If you mean the car's been chipped to increase performance, no I don't think there's any way it could reset due to a flat battery.
HTH, Pete
Hiya,
in my opinion - yes. I faced the same dilemma when I replaced mine, and a non-genuine Scantech part sadly didn't last nearly enough miles before the balljoint was shot again.
I'm now...
Hiya,
the tip was from Tony - the Toyota MR2 uses the same bushes, and eBay sellers from the US sell the brass bushes as a mod.
Can't really tell what difference they made, as I fitted them...
EDIT I crossed posts with Tim - thanks Tim.
Is it possible the manual 850Rs had whites to go with the 16T turbo? I don't know I'm afraid.
Mine is (was) an auto, so had the 15G turbo also found...
Hiya,
here's a link to the HowTo if you're interested.
http://www.volvoforums.org.uk/showthread.php?t=71697
Cheers, Pete
Yep, a common failure item I think. I've replaced mine at least.
Cheers, Pete
I don't have much info but I don't believe there's anything you can do when changing rear discs that would cause the rear alignment to go out.
HTH, Pete
Well it had stopped raining, and I was already in the shed getting Torx drivers to go and remove an indicator stalk and... But I digress :-)
Cheers, Pete
OK, 41mm according to the vernier calipers but as it's rubber it's a bit give and take... Could have seen measurements from 40.5 to 41.5mm.
Cheers, Pete
Don't remember it as too bad. Tricky bits are you might need some specialist tools. On several driveshafts I've been able to loosen the nut then whack the end with a mallet and a suitable drift (e.g....
Hiya,
it is bolted pointing into the top of the gearbox bell housing with a single black torx bolt. The housing it's in is ally, bolted and dowelled to the side of the block with 2 hex nuts.
...
Mine's on 135k miles and has been on track days, dyno days and drag strip days. The car's modified as well so it's running above-standard power.
I suspect as with everything there's a bit of luck...
Hiya,
I think the main signs are a clunk engaging 1st or reverse when setting off.
Basically, check the fluid level is OK, and the condition is good (red, translucent not black and opaque).
...
http://i267.photobucket.com/albums/ii300/DOO13Y/RedlineVolvoArticle.jpg
Cheers, Pete
Hiya,
measured the drivers seat from a CD spec model (full leather, heated, electric) at 27.5KG today. The passenger is heated, full leather but manual - I'll try and measure that within the next...
Hi,
it doesn't really matter - they both read the same thing (boost pressure). I personally find it a bit easier to work in PSI, which may range from about 10 to 20 between a stock and tuned car....
There wasn't on our year of car, but they did fit them to later cars so you can choose to fit them if you wish. IPD lists the Volvo part numbers here:
...
Hiya,
in section 6.6, the 2nd picture shows roughly how to change main beam bulbs and "daylight runner" bulbs. Daylight runner bulbs are the same as dipped beam but I think are run slightly dimmer...
Hi,
you don't need to remove the headlamps or wipers to change the bulbs. The main beam and dipped beam are accessed by unscrewing a round black plastic cover in the back of the headlamp unit. The...
Hiya,
I think the pipe from Volvo comes with the larger bore pipe that comes out of the PCV canister and also goes to the thermal valve on the turbo intake pipe.
If you wanted, there's no...
Hiya,
in my experience it would need to be at least 16mm spacers to fit 993TT calipers under Volans. I had 15mm ones and they wouldn't quite clear.
For my 17" Pegasus I'm running 3mm spacers. I...
Hiya,
I used Porsche 993 Twin Turbo front calipers.
I got mine from eBay seller msroadrace in the USA but they don't have any at the moment.
I checked the part number of the ones I wanted...
Hiya,
I took some photos of what my catch tank collected:
http://i267.photobucket.com/albums/ii300/DOO13Y/Photo027sm.jpg
http://i267.photobucket.com/albums/ii300/DOO13Y/Photo028sm.jpg
...