On my V50 I have 2 bent rims. I've got 17" Zurak wheels which are proving hard to come by. So.... I'm thinking of looking at alternatives. Here's my car
And these are the wheels I'm thinking of fitting
So, do you think it'll look great on my motor and do you think they'll fit?
TT
What's the et etc on the new rims?
Get someone to photoshop them onto the car , where is Liberate when you need him ? They look like nice wheels mate , the Rashermobile will suit them.
Yeah, Liberate would have been the man for that job.... It'd certainly make it easier to decide Orca
[QUOTE=twr;780324]What's the et etc on the new rims?[/QUOTE] Don't know what you mean
Any wheel that has a clear coat Finish on alu will start to corrode from the edge in , just a thought. PS they are smart looking rims..
[QUOTE=The Thong;780333]Don't know what you mean[/QUOTE] What is the width and offset of the wheels you have your eyes on, you need to compare to your current wheels so you'll know how set into the arches the wheels are ;)
If I've got this right, the tyre size is the same but my current offset is 45mm the 17" Ixiom rims are 50mm. I'm still trying to nail down the stud spacing and stud size TT
The stud pattern will be the same, 5x108. So with that difference in offset the wheels will be set into the arches 5mm more than your existing wheels ;) (assuming they are the same width).
Harvey made a good point about clear lacquered alloys, they can be a beehatch to keep, the slightest pin£££££ leads to the dreaded " alloy worm tracks " creeping across the surface.
Nice wheels thong should be loads of options open to you ford fitment aswell don't forget ;)
Found this photo of a normal V50 with 17 inch Ixions, looks good. [ATTACH=CONFIG]29391[/ATTACH]
They look great, it looks like its moving when its standing still. Buy them Thongster, the Church of The Lard compels you.
That sorts that then, they fit. I'll keep scratch eye out now TT
I may have a full set of your original wheel that may be available, just need to check and I'll let you know if your interested
Ok, let me know. I'm assuming they're straight? Sorry, gotta ask. TT
[QUOTE=AcidicDavey;780372]The stud pattern will be the same, 5x108. So with that difference in offset the wheels will be set into the arches 5mm more than your existing wheels ;) (assuming they are the same width).[/QUOTE] Tyre size is the same... It's looking optimistic TT
Even if they didn't you could make them fit :P Worst case scenario is you'll need 5mm spacers but I highly doubt they'll be necessary!
Judging by the picture of the V50 above its not going to be a problem. The tyre size matches, I had a shufty at a V40 while I was at the dealers today. I'm confident But.... If a set of Zurak's come up then I'll stick to the original spec TT
Ixion is the name and by far the best looking Volvo wheel imo. They'd look superb on your car mate.
Try this website when comparing wheel sizes, offset etc: http://www.willtheyfit.com/
[QUOTE=The Thong;780410]Ok, let me know. I'm assuming they're straight? Sorry, gotta ask. TT[/QUOTE] as far as I'm aware they are, but will check at the this weekend and get back to you.
Cheers matey TT