I think I might just invest in one of these:
http://www.ebay.co.uk/itm/TURBOCHARG...item4ac2d41eb2
I think I might just invest in one of these:
http://www.ebay.co.uk/itm/TURBOCHARG...item4ac2d41eb2
PIC][/SIGPIC]
aaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaa
Facebook^^^^^^^^^^^^^^^^ Old T-5 Kompressor Thread^^^^^^^^^^^^^^^ New TT-10 Kompressor Thread
I don't think thats a bad idea Col
thats a bit steep considering you'll only use the one size. Using a hole saw i just cut a MDF blank the size i need (3") & fitted a spare compressor fitting i'd got, job done
I've also cobbled one up in the past, but it would be quite nice to have one on the forum, like the code reader and could be loaned out when needed.
PIC][/SIGPIC]
aaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaa
Facebook^^^^^^^^^^^^^^^^ Old T-5 Kompressor Thread^^^^^^^^^^^^^^^ New TT-10 Kompressor Thread
I made one up using a hub nut cover off the back of a saxo and drilled it to take a tyre valve.
Old Car: 855 T5 in Grey and rust (dead and gone, well, most of it !
Missus' ride: Citroen C4 coupe 1.6 HDi,
Modifications: Nowt.....yet !
Daily driver: 855 R in Black,
Currently nursing a blown head gasket, new engine on its way !
Recent addition: Freshly imported Honda Stepwagon,
Slowly turning into a camper van !
19t, greens, 3" inlet, 3" downpipe with race cat, V70R catback, autotech map...
310.2bhp / 333ft/lb
2016 Swedish Day UK "Best Modified Swede"
SOLD
Got an old discovery now.
jdavis (Friday 4th October 2013)
could buy a few billets off alloy and drill and tap them so a hose tail can be screw in. bet can be make for peanuts
s60 2.4 t5 eibach springs,up rated rear anti roll bar, poly bushed wishbones, poly lower engine mount, fmic, bmc air filter, 3" decat, 2.5" stainless exhaust,hlm remap 328bhp,
let me know if want me to price up the alluminum. ill need to know the size though
s60 2.4 t5 eibach springs,up rated rear anti roll bar, poly bushed wishbones, poly lower engine mount, fmic, bmc air filter, 3" decat, 2.5" stainless exhaust,hlm remap 328bhp,
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks