V70 P2 rear camber adjustment

**RobbieH** · Tuesday 30th June 2009, 09:10

Following up from my earlier post on the suspension upgrades.

I understand that the front end has been toed and cambered to match the new lowered setup. But, the rear is 40-70 minutes out of camber (can't remember which way round side to side) which I think means the inside edge of the tyres could wear faster than the outside.

I've seen the camber adjustment bolts on PFV but these are for the front end. What can be done for the rear end?

**harleyvh** · Wednesday 22nd July 2009, 15:52

I'm researching a solution to fix a negative rear camber situation in my V70.

Here is what I found so far:

1) IPD makes a rear camber kit for the P2 AWD models only.
http://www.ipdusa.com/nl-15-74

2) Spring Distance Kits
Suspension Techniques (part 30003) and Weitec (part 68530032) are making a spring distance kit that raise the rear by about 0.8" that should be enough to fix the negative rear camber situation. However parts are hard to find and are actually back order. Weitec parts should be easier to find on your side of the pond....

3) Adjustable rear camber plate
That could be a solution however did not find any part for our V70.

That's basicallly it so far.
Not sure if this can help

Keep us posted on what you find