How to fit dump valve v70R 1997

[rise94]

is their anyway to get the pictures back on this thread so I can do mine please

Sorry for the translation because the tutorial is mine and is in french at the start.

Kit dump valve BAILEY DV26+kit FK80(Tee).Buy on MOTORBLING Ebay UK.

1- Remove all power to the right of the hose . Nothing out, it's just get on a slide .
2- Remove the hose. 2 necklaces to remove aevc a screwdriver or socket 7mm .
3- Presentation Kit FK 80 is simply unequal tee alu.Although identifying the place that will take the tee in the hose . Here I made the tape.
As I decided not to remove 2 or 3cm hose to let pass the small part of the tee I draw a line with the tape to well cut right to cutter .
-4 - ATTENTION HERE ! I made ​​a mistake in identifying the hole that I was going to pass the small part of the tee.
You must tilt the hole 60 ° , approximately , for a time the dump valve mounted does not bother closing the hood .
So I put a tape on each cut hoses, use a socket the same diameter as the small portion of the tee and route for power cut.
-5- cutting checks to cuter.On installation ( so then I made ​​a mistake because the first cut is perpendicular to the hose horizontal position . So I did another hole at 60 ° to the intake manifold !
With this cut , you have loss of material , to finally get what I wanted anyway. Replacing the complete hose.