Unless you know what you are doing - don't fiddle!
The actuator needs to be set to 4 psi (the pressure before the wastegate opens). Overtightening the wg rod will lead to a world of pain (overboosting & bent con rods).
To set it properly you need an accurate pump with a gauge.
Remove the heat sheild.
Disconnect the vacuum line into the actuator.
Remove the pin on the wastegate end of the wg rod.
Slide the wg rod off the top of the wastegate hinge
undo the 10mm locking nut on the wg rod
Connect the pump to the actuator
pump the actuator upto 4psi
adjust the wg rod so that the hole slides into position on the wg hinge pin (without hinderance) with the gate closed.
Reassemble
If you have any questions then this means you don't understand which means you shouldn't fiddle.
Be warned !
Bookmarks