Snabb have made the short shift kit for V70R S60R cars again.
I got mine to fit so thought I do a how-to guide.

So here it is.



First job remove the gear knob which is very easy just push down & turn then it just lifts off.


Then just pull the trim up from the roller cover it unclips no screws.

Then the silver dome is held in with clips no screws.





Then you need to pop the L/H ball joint.I used a big flat bladed screw driver .



Then remove the 3 screws that hold the black plastic ring around the rod.



Then remove the white plastic surround it just lifts out.



Then remove the spring type clip from the shaft sorry didn't get a photo, but this is the clip. IMPORTANT TIP have a very good look at the spring that centers the gear knob ,and the plastic stops for it ,I didnt so had a funny five minutes when refitting it.



Then you need to remove the gear cable from the bottom of the gear lever, I used a long 17mm spanner it just poped off .

Now you can lift out the gear shaft assembly, you need to remove the white clip around the ball & "O" ring



I had a new holder but to be fair the old one was fine.



Now you need to remove the bolt & steel bush that fixes the base to the car.





Now you have to trim / cut a plastic web out or the shift cable will hit the web. I used a die grinder as I have one .






Then I did trim the steel bush.