Gear change cable bush help

[AAN]

I am going to do the manual conversion to my R and I wanted to buy some bushes for the gear cables and the set I have seem worn, I have seen on some posts that people use the mr2 bush kits my question is am I looking at the right set in this picture or is there others I can buy any help would be great many thanks

[JeanPete]

I personally used some spherical shifter bushing kit designed by CRW garage for MR2 : http://www.mr2.com/forums/threads/88...er-bushing-kit

It's different stuff but size may be the same. Then this was quite tight though, but it didnt matter as mines were made to move on their center.

[MoleT-5R]

It is also possible to use proper bearing in the cable ends as Claymore has on his 850 http://www.ebay.co.uk/itm/2007097597...%3AMEBIDX%3AIT will just depend on the size of the cable ends on your model

[AAN]

Great advice thanks will be measuring them up later

[MoleT-5R]

these where my custom made ones, but tbh it's a lot of faff as the one's Colin's used are dirty cheap and off the shelf, but I do like to make stuff for my car.

[kmb]

Mine are also identical to those pictured by Mole, they do make a nice difference to the directness of the gear change

I did the same on my Rev 3 MR2 Turbo, but with the ebay kit linked, similar affect.

[claymore]

You can't see very well here, but I use four bearings per gearbox, two with a flange and two without.