Have found a pic on my phone will try upload tomorrow morning, in mean time I will try explain a little better go to the nearside rear wheel look under the car from the rear of the wheel so your head is near the tail pipe , you will see the rear arm running from the rear suspension back towards the centre of the car. About 3/4 of the way along it there looks to be a u shaped shield. Sat in this u shaped shield is the self leveling ride sensor. One end should be attached to the bottom of the arm there is then a rod/arm with an elbow half way along it going to small box. The bracket at the bottom of the arm rusts and breaks free of the suspension bottom arm allowing the sensor arm to drop below the suspension arm this then reads on the sensor as if the car is heavily loaded and therefore drops the level of the head lights
Bookmarks