2.3 t5 rear wheel drive. Advice needed about parts.

[tonysierra]

could someone please give me a list of parts i need to complete a t5 rear wheel drive conversion. parts are off v70,pre me7, v70 me7 and 960 manual. donor cars need to go so want to get all parts off that i require. thanks and any info realy appreciated.

[claymore]

as long as you have the complete engine loom with the engine you're going to use, you should be fine.

[Doingitsideways]

Don't forget the starter motor bracket from the 960.
They're made of unobtanium!!

Aren't you also on VOC?
Isn't this little lot going in a 3 door shell??

[tonysierra]

it is supposed to be but no time. need to get rid of the 3 donors so only want to keep the parts i i'm going to use.

Don't forget the starter motor bracket from the 960.
They're made of unobtanium!!

Aren't you also on VOC?
Isn't this little lot going in a 3 door shell??

[richcoad89]

Are you sticking it in the back of the car or front? If in the front you will need an appropriate gearbox and adaptor.
A lot of time, and be prepared to spend out on quite a few things (prop shaft, rear diff complete with subframes, rear suspension, drive shafts and wheel hubs etc).

[tonysierra]

i have a complete 960 with the m90 box. the prop can be sorted quite easily and i will use the rear end off my sierra. just trying to work out exactly what i need off each car so the rest can go.



as long as i don't need to modify the car too much it should be ok.