Hi,
I'm new to this forum and reasonably new to Volvo's, I'm getting mine (1997 volvo 940 2.3 lpt torslanda) in the next month or so and am looking at the usual mods: exhaust, intake, rising rate FPR. i am also looking at either running a lot more boost (approx 20psi) from the stock turbo or worst case a bigger (t3 or g15) turbo and running the green injectors I've heard so much about.
www.ebay.co.uk/itm/321196442392?ru=http%3A%2F%2Fwww.ebay.co.uk%2Fsch% 2Fi.html%3F_sacat%3D0%26_from%3DR40%26_nkw%3D32119 6442392%26_rdc%3D1[/URL]
know this is where I'm a bit hesitant and i lack some knowledge, this is where some help would be much appreciated.
are these correct? are these a direct replacement? no modification required to get the to fit and work?
I've heard of a resistor mod, using a ballast resistor to lower the resistance. do i need one or do i need four, how do i wire them in, how do i no Im getting the rite resistor(s)
i understand i will need, or at least its a good idea to run a 3" MAF sensor to get the most out of these injectors, i also intend to get it re-mapped which i believe is a chipping job and most likely run an uprated intercooler, the general stuff to support these mods and get the best out of them.
some help with these injectors would be much appreciated, i will upload some photos when i get the vehicle.
thank you
Bookmarks