Hi folks, happy Saturday
Finally finally got round to looking at swapping the cylinder head on the Shark.
The head is the one from Blackbeast's car, with some machining work by Tim Williams (I will dig out the spec on it). Does anyone have any recommendations for jobs that should be done before fitting?
Timing belt tensioner
Water pump
ME7 manifold
Valve seals/seating
???
'Consumables' I will need cylinder head bolts, a gasket/seal kit, timing belt....I'm looking for the best place to source genuine/equal quality items.
Any suggestions would be much appreciated. I'll get the PCV stuff done also while in there, that I already have.
Hope to get this all done prior to Crail on the 16th!!
Bookmarks