white smoke

[T5frankie]

I bet i could get the water hoses done white to. be a nice finishing touch

yeah would be, to be honest i havn't tried to locate any

[graemewelch]

yeah would be, to be honest i havn't tried to locate any

ill enquire with the company who make my hoses if you want. just been out messing with a 3" intake i made. i rekon you could use it with a 45 degree hose or 90 degree saying as you dont need to be exact with you cone filter.

[T5frankie]

ill enquire with the company who make my hoses if you want. just been out messing with a 3" intake i made. i rekon you could use it with a 45 degree hose or 90 degree saying as you dont need to be exact with you cone filter.

cheers matey

[graemewelch]

just needs extending abit for a bit white hose

[AndysR]

Good work Frankie, pleased that the engine isn't goosed

Get yourself a clip on that actuator pipe though for goodness sake

[T5frankie]

Good work Frankie, pleased that the engine isn't goosed

Get yourself a clip on that actuator pipe though for goodness sake

won't come off mate too tight pmsl

[T5frankie]

just needs extending abit for a bit white hose

kooks good mate, would match my 3" maf i aint using yet

[graemewelch]

kooks good mate, would match my 3" maf i aint using yet

it could be yours. i need to generate some cash for other stuff

[AndysR]

won't come off mate too tight pmsl

So long as you're sure

[T5frankie]

it could be yours. i need to generate some cash for other stuff

i just need to generate cash lol

[Kingsford G]

ok for the last hour i have re-done the pcv system, what i have done is replaced the brittle plastic pipes with 4mm silicone hose for the vacuum and 5/8ths heater hose, i bought a metre of each off ebay, the heater hose is actually the perfect fit on each end, i whacked it all back together, (and also changed back to white injectors whilst they were off) I then ran the car up to temperature and took the dipstick out and?????????? no white smoke no smoke of any kind, so well chuffed and i would recommend this mod to anyone

I`m glad its all good mate.The car looks a lot better since I`ve last seen it,the shiny bits look ace and good job you painted the inlet many black,looks a lot better.Hope to see it at Uxbridge dyno.

[T5frankie]

I`m glad its all good mate.The car looks a lot better since I`ve last seen it,the shiny bits look ace and good job you painted the inlet many black,looks a lot better.Hope to see it at Uxbridge dyno.

cheers mate, at this rate it will be the 1st time i get it on the dyno so will be a surprise what it's pushing

[Jamest5r]

Nice one mate well chuffed for you

Hope it's not too fast though lol

[T5frankie]

Nice one mate well chuffed for you

Hope it's not too fast though lol

i think you should do the same jim as yours is puffin'

[Jamest5r]

i think you should do the same jim as yours is puffin'

3" dp, oil cooler, 3" maf plus mapping got enough on my plate and I'm skint lol

[T5frankie]

3" dp, oil cooler, 3" maf plus mapping got enough on my plate and I'm skint lol

mate it only took me an hour and cost about £7 so better than blowing the RMS