worn top mount

**jdavis** · Tuesday 3rd September 2013, 13:55

I think this definitely past its best

**M-R-P** · Tuesday 3rd September 2013, 14:07

Not that bad - call it weight reduction

**graemewelch** · Tuesday 3rd September 2013, 14:17

there like that when new, im going to get a poly bush. standard design is chod

**Dangerous Dave** · Tuesday 3rd September 2013, 14:52

Nothing wrong with that, looks about the same tolerance they used for early steam engine drive gear

**jdavis** · Tuesday 3rd September 2013, 15:08

Like that when new?! That's just asking for problems caused by wear. Will be ordering a couple of bits next pay day so best make poly bush one of them.

**M-R-P** · Tuesday 3rd September 2013, 15:10

Originally Posted by jdavis

Like that when new?! That's just asking for problems caused by wear. Will be ordering a couple of bits next pay day so best make poly bush one of them.

if you want to keep your fillings, get the strut brace tensioners to go with it

**Biff** · Tuesday 3rd September 2013, 15:31

Mines off an me7 engine I've found out.
Up to you if you want it mate or I'll send it back for a refund.

**M-R-P** · Tuesday 3rd September 2013, 15:48

Originally Posted by Biff

Mines off an me7 engine I've found out.
Up to you if you want it mate or I'll send it back for a refund.

Your bush won't fit that mount - unless the ally bracket is off an ME7...?

**Biff** · Tuesday 3rd September 2013, 23:48

It is an ally bracket off an me7. That's why it won't go anywhere near mine. It came off a 2001 c70 t5 & the lad said he thought it would fit.
Computer says no. Do not pass go.
So I'm selling the yellow & fitting the purple. You were right all along Martin.