snaab pipe are they worth it

**graemewelch** · Tuesday 30th July 2013, 15:03

£170 for the silicone pipe. ill give that a miss

**M-R-P** · Tuesday 30th July 2013, 15:05

Originally Posted by graemewelch

£170 for the silicone pipe. ill give that a miss

**graemewelch** · Tuesday 30th July 2013, 17:02

Originally Posted by Wobbly Dave

for the PTC valve? I have one of those.

wear did you get the grommet from dave. i might build a couple of these. every penny counts for me at the minute.

**graemewelch** · Tuesday 17th September 2013, 14:22

just a quick sneaky pic of a w i p pipe. need to drill it for the dromet and wel to nipples on then get it painted satin black. no shinney bits under my bonnet

just about to order the mikalor clamps for it. hopfully all finished by the weekend and ill start on the throttle body to ic.

**M-R-P** · Tuesday 17th September 2013, 15:00

Looks a lot like mine

**partsforvolvos.com** · Tuesday 17th September 2013, 16:29

that looks nice graeme.

**graemewelch** · Friday 25th October 2013, 17:29

been messing about since getting the ac welder. but knocked this up while i had a spare half hour.

**Rnash2002** · Friday 25th October 2013, 17:44

Sure just get a bit of samco with the seprate pipe then your sorted.

**V70 Graham** · Friday 25th October 2013, 17:57

Originally Posted by graemewelch

been messing about since getting the ac welder. but knocked this up while i had a spare half hour.

Looks familiar lol

**silverhorse** · Friday 25th October 2013, 18:05

I like that Greame, looks good. I bet that did not cost you what they sell for!!!
Just found this thread and it looks very interesting. Are the pipes you made a bigger bore than the standard? How does it sound and what is the drive like now? Smoother, more responsive?
Wish I had the skill and confidence to do things like this!!! If it all works well, will you be open to orders??!!

btw, was it you who said a while back that you were going to make some hub bolt kits and sell them on ebay? If so, have you done any?

**graemewelch** · Friday 25th October 2013, 18:09

Originally Posted by silverhorse

I like that Greame, looks good. I bet that did not cost you what they sell for!!!
Just found this thread and it looks very interesting. Are the pipes you made a bigger bore than the standard? How does it sound and what is the drive like now? Smoother, more responsive?
Wish I had the skill and confidence to do things like this!!! If it all works well, will you be open to orders??!!

btw, was it you who said a while back that you were going to make some hub bolt kits and sell them on ebay? If so, have you done any?

im planning on knocking them out. ive done this one to test it out. it was prob me but ive been unable to get my hand on a hub or axle.