how do you fit a cam pulley so the timing marks are in the correct place??
3 bolts, 3 slots, 3 options............
are there any marks I should look for??? I cant see any
cheers
JT
On the other end of the cams ( dizzy/sensor end ) they are notches which I think need to be horizontal.
1996 850 T5 AWD - Self tuned M4.4 ECU with COP`s, B5254T ( S60R internals in a 850 block ) ostrich 2.0 , VXR injectors @ 3.8 bar, K24 turbo with a 6+6 compressor wheel, 3.25" MAF, top mounted Dump Valve, RN Exhaust manifold, 3" downpipe with 200 cell cat, 2.75" Stainless exhaust, Brembo calipers, S60R brake discs, stainless RIP kit, 3" Throttle body,
The slots in the rear of the cams are offset , they need to be set horizontal but the slots are one above centre and one below (if that makes sense), I made a locking tool out of a piece of dexion angle with plates bolted onto them.
Old Car: 855 T5 in Grey and rust (dead and gone, well, most of it !
Missus' ride: Citroen C4 coupe 1.6 HDi,
Modifications: Nowt.....yet !
Daily driver: 855 R in Black,
Currently nursing a blown head gasket, new engine on its way !
Recent addition: Freshly imported Honda Stepwagon,
Slowly turning into a camper van !
JT (Tuesday 30th April 2013)
Yep, the cams are offset
This might help, I set mine up by eye, when I finally got it checked with a locking tool, it was only a couple of degrees out
http://www.justanswer.com/volvo/1942...der-xxxxx.html
JT (Tuesday 30th April 2013)
I did see a tool on ebay for aligning up the cams
1996 850 T5 AWD - Self tuned M4.4 ECU with COP`s, B5254T ( S60R internals in a 850 block ) ostrich 2.0 , VXR injectors @ 3.8 bar, K24 turbo with a 6+6 compressor wheel, 3.25" MAF, top mounted Dump Valve, RN Exhaust manifold, 3" downpipe with 200 cell cat, 2.75" Stainless exhaust, Brembo calipers, S60R brake discs, stainless RIP kit, 3" Throttle body,
PIC][/SIGPIC]
aaaaaaaaaaaaaaaaaaaaaaaaa
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaa
Facebook^^^^^^^^^^^^^^^^ Old T-5 Kompressor Thread^^^^^^^^^^^^^^^ New TT-10 Kompressor Thread
JT (Tuesday 30th April 2013)
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks