Join Today
Results 1 to 7 of 7
  1. #1
    Trader
    This user has no status
    Kingsford G's Avatar
    Join Date
    Nov 2011
    Location
    Colchester,Essex
    Posts
    6,115
    Thanks
    1,352
    Thanked 1,665 Times in 1,419 Posts

    S80 D5 a few problems.

    I hope someone can give me good tips on this.I bought an S80 D5 wiv a few probs:
    1.cam or followers knocking over 1400rpm
    2.white smoke under load manly
    3.difficult to start cold or hot
    4.a yellow triangle wiv exclam mark in the middle lids up every time u touch the brake pedal and goes off when released.
    The car has 106k done wiv FSH.Any help would b great.

  2. #2
    Senior Member
    ...here we go again...
    LeeT5's Avatar
    Join Date
    Oct 2004
    Location
    Kent
    Posts
    5,337
    Thanks
    1,075
    Thanked 1,393 Times in 1,068 Posts
    The mileage isn't that high, have you had the codes read?

    Without seeing the car it's impossible to make accurate suggestions but if you want my advise then start with an engine flush followed by an oil change. You never know, that might sort out you noisy hydraulic lifters.

    The warning triangle that comes on may be low brake fluid due to heavily worn brakes. For the record, it would have thrown a fault code for that so get the codes read.

    Check coolant level and specific gravity. If it's weak then it will indicate the previous owner has been topping up. Most Joe public wouldn't think of using a 50/50 mix to top up so the specific gravity will be low. Especially as the car has FSH, FVSH would have been better!!
    If the gravity is low then suspect a leak. This might be the cause of your white smoke under load....the beginning of the end.

    Difficulty start when hot OR cold usually indicates worn pump, worn injectors or possibly and more commonly a sticking EGR valve.
    Again, fault codes will indicate this. DOn't bother to clean, it's fruitless and will never be 100% right. If it is the EGR then replace it.

    Hope that helps, good luck.
    Last edited by LeeT5; Saturday 19th May 2012 at 09:40.
    2014 V60 Polestar 6spd Auto :: Polestar map peak boost 17.4psi :: IPD 3" DP + 150cel :: Polestar 2.5" exhaust :: Paddle Shift Geartronic :: Black glass :: Maxton Splitter :: K+N Filter :: IPD Aluminium Top engine mount :: Brembo 6 pots :: 20" Polestar rims :: Brembo 371mm floating discs :: Sensus RTi + DAB + BT + WIFi :: D3S XENARC 6000k Active bending headlights

  3. The Following User Says Thank You to LeeT5 For This Useful Post:

    Kingsford G (Saturday 19th May 2012)

  4. #3
    Senior Member
    Gizza job!
    Yosser's Avatar
    Join Date
    Jul 2008
    Location
    The 1980's
    Posts
    1,068
    Thanks
    161
    Thanked 417 Times in 315 Posts
    4: brake light bulb out

    For the rest, get the codes read and give it a good service. Check for intercooler leaks, they're famous for intercoolers.

  5. The Following User Says Thank You to Yosser For This Useful Post:

    Kingsford G (Saturday 19th May 2012)

  6. #4
    Trader
    This user has no status
    Kingsford G's Avatar
    Join Date
    Nov 2011
    Location
    Colchester,Essex
    Posts
    6,115
    Thanks
    1,352
    Thanked 1,665 Times in 1,419 Posts
    Thanx guys,will read the codes on monday and let u know.

  7. #5
    Trader
    This user has no status
    Kingsford G's Avatar
    Join Date
    Nov 2011
    Location
    Colchester,Essex
    Posts
    6,115
    Thanks
    1,352
    Thanked 1,665 Times in 1,419 Posts
    Ok I thought my s80 is d5 but it is the earlier model wiv 2.5 vw engine.So the starting problems solved by setting up the fuel pump timing as was done wrong when some one changed all the belts less than 200miles ago.Now she starts from turn of the key but still smokie as I`ve heard these r very fassy on timing.In my timing autodata there is no s80 0r s/v70 2.5 belt set up so I used a vw set up using a dial gauge and moved it 55m from dead poin but I`ve red in some cases u have to go as far as 70mm.As I said starts on the button now but smokei.If anyone has set fuel pump timing on one of these plz let me know how much did u move pump pulley.

  8. #6
    Senior Member
    ...here we go again...
    LeeT5's Avatar
    Join Date
    Oct 2004
    Location
    Kent
    Posts
    5,337
    Thanks
    1,075
    Thanked 1,393 Times in 1,068 Posts
    i would think the best thing to do is speak to a VW tech or specialist.
    2014 V60 Polestar 6spd Auto :: Polestar map peak boost 17.4psi :: IPD 3" DP + 150cel :: Polestar 2.5" exhaust :: Paddle Shift Geartronic :: Black glass :: Maxton Splitter :: K+N Filter :: IPD Aluminium Top engine mount :: Brembo 6 pots :: 20" Polestar rims :: Brembo 371mm floating discs :: Sensus RTi + DAB + BT + WIFi :: D3S XENARC 6000k Active bending headlights

  9. The Following User Says Thank You to LeeT5 For This Useful Post:

    Kingsford G (Friday 25th May 2012)

  10. #7
    Trader
    This user has no status
    Kingsford G's Avatar
    Join Date
    Nov 2011
    Location
    Colchester,Essex
    Posts
    6,115
    Thanks
    1,352
    Thanked 1,665 Times in 1,419 Posts
    After a little run seem ok now,poss had abit to clear after running 200miles since some cowboy did the cambelt and pump belt.Thanx Lee.


 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.
     
ipv6 ready