850 saloon ice questions

**the flying scoT5man** · Wednesday 25th April 2012, 14:24

hey guys,

Any of you installed subwoofers in the boot of the saloon other than the wheel well?

Also components is there space to run wires through the door to the amp in the boot?

Any links to stealth boxes for the saloon?

And can any of you nice chaps that have installed subs in a saloon post some pics here so i can have a butchers cheers

I have 2 12" subs 3 amps a crossfader components and plenty of wire to install but looking for ideas before i go down the MDF custom box route again lol

**p fandango** · Wednesday 25th April 2012, 16:22

must admit i only fitted mids into the doors, & used the original wiring thru the doors

**M-R-P** · Wednesday 25th April 2012, 16:44

Lol, looks a bit different now tho Pedro

Anybody who uses the Mortal Kombat logo as a Volvo avatar should be treated with respec' lol. Keep us posted on how the install goes mate.

**p fandango** · Wednesday 25th April 2012, 16:47

Originally Posted by martinrpeachey

Lol, looks a bit different now tho Pedro

poor BT's been thru a few different phases in her life, i think the weight-watchers diet's her final one lol

**the flying scoT5man** · Wednesday 25th April 2012, 20:05

cheers for the pics

keep them coming guys

Was a hard choice for the avatar but had to be the MK Volvo

**p fandango** · Wednesday 25th April 2012, 20:12

found some other pics, just not very good one's lol

**the flying scoT5man** · Wednesday 25th April 2012, 20:19

Like the boot lid build and the floor amp set up think i may have to just check the door loom plug and see if i can make room for the component power leads down to the amp and maybe just have to fabricate the mdf to fit snug with subs at the back seats and house 2 amps on 1 side of boot and the 3rd amp and cross fader in the other side. Need to get some dynomat first though lol

**p fandango** · Wednesday 25th April 2012, 20:25

Originally Posted by the flying scoT5man

Like the boot lid build and the floor amp set up think i may have to just check the door loom plug and see if i can make room for the component power leads down to the amp and maybe just have to fabricate the mdf to fit snug with subs at the back seats and house 2 amps on 1 side of boot and the 3rd amp and cross fader in the other side. Need to get some dynomat first though lol

i didn't use any dynomat. As you can see the amps on the back of the seats works well, & i had my cross-over in the side of the boot & an amp the other

the wiring hidden under the seat