injectors

[gavt5]

i am after some 750cc injectors for my t5 pre-me7. i have seen some uprated mk2 focus RS high impedance bosch ones cheap and was wondering if anyone here knows if the mk2 focus rs injectors would fit the t5 fuel rail as its a volvo derived 5 pot?

[smithy]

i am after some 750cc injectors for my t5 pre-me7. i have seen some uprated mk2 focus RS high impedance bosch ones cheap and was wondering if anyone here knows if the mk2 focus rs injectors would fit the t5 fuel rail as its a volvo derived 5 pot?

why do u need them so big mate what turbo u running

[gavt5]

garret gt3782 a/r.54 t1.12

[smithy]

garret gt3782 a/r.54 t1.12

ok understand that will be good threw the front wheels all i have to say is see u on the track in my 940 lol

[T5frankie]

whoa nice turbo yum yum

[gavt5]

understeery wheelspin.com. pointless really as its wrong wheel drive but it is ironically funny in a volvo estate. rear drive, even if with less power will beat me round track no probs. so injectors?lol

[T5frankie]

so why aint you been here before with a monster like that?

[gavt5]

dont really do forums mate tbh, as i dont get much time to go on them, update build thread etc

[T5frankie]

dont really do forums mate tbh, as i dont get much time to go on them, update build thread etc

i know what you mean but there is a wealth of knowledge on here and some good meets, like tomorrow we are going to do the 1/4 mile at avon raceway, which your car would be awesome at btw, sure someone will know the answer to your question

[gavt5]

cars only on a little 19t atm so 330ish? bhp but im just running round on that while im building the proper lump. also not going to be gr8 up strip as havent fitted my diff yet

[T5frankie]

cars only on a little 19t atm so 330ish? bhp but im just running round on that while im building the proper lump. also not going to be gr8 up strip as havent fitted my diff yet

well mine is on 311bhp at 18psi on a little 19t lol

[Volvostorm]

garret gt3782 a/r.54 t1.12

Wow! That makes my turbo look tiny!

[gavt5]

makes for a quick car i agree, mynes mapped at 22psi atm and for a big heavy old slug they go well but for proper 60-130mph performance itll need a much bigger turbo, will also move the power band higher in the rev range, so for top end would be better imho. 19ts and k24s are better than the 16ts for power but depends what type of car your building i suppose. when finished my car wont be especially nice to drive every day but its not my daily, just a bit of cheap fun. as a daily 300bhp is plenty to play with and im sure suprises the uninitaited

[T5frankie]

so its running off the bcs at 22psi? who mapped that? take it your have a forged bottom end?

[gavt5]

running a blitz dsbc and was mapped by a friend. standard (rebuilt) bottom end. it will eventually go onto a emerald k6, coil on plug ignition, 3 bar map sensor etc. this scurrent spec is just to smoke around in

[mitchyboy01]

Hi mate. Get these and turn up fuel pressure slightly. The can run 30-100psi and over 900cc at highest pressure.

http://www.ebay.co.uk/itm/Siemens-De...#ht_4199wt_821

[gavt5]

are they a direct fit for the t5 fuel rail? right length/thread etc? just curious as quite cheap compared the bosch no?

[smithy]

Hi mate. Get these and turn up fuel pressure slightly. The can run 30-100psi and over 900cc at highest pressure.

http://www.ebay.co.uk/itm/Siemens-De...#ht_4199wt_821

they look familar lol

[Volvostorm]

Deka's fit just fine, I have them in mine

[gavt5]

do you run these then smithy?