i am after some 750cc injectors for my t5 pre-me7. i have seen some uprated mk2 focus RS high impedance bosch ones cheap and was wondering if anyone here knows if the mk2 focus rs injectors would fit the t5 fuel rail as its a volvo derived 5 pot?
i am after some 750cc injectors for my t5 pre-me7. i have seen some uprated mk2 focus RS high impedance bosch ones cheap and was wondering if anyone here knows if the mk2 focus rs injectors would fit the t5 fuel rail as its a volvo derived 5 pot?
garret gt3782 a/r.54 t1.12
whoa nice turbo yum yum
understeery wheelspin.com. pointless really as its wrong wheel drive but it is ironically funny in a volvo estate. rear drive, even if with less power will beat me round track no probs. so injectors?lol
so why aint you been here before with a monster like that?
dont really do forums mate tbh, as i dont get much time to go on them, update build thread etc
cars only on a little 19t atm so 330ish? bhp but im just running round on that while im building the proper lump. also not going to be gr8 up strip as havent fitted my diff yet
makes for a quick car i agree, mynes mapped at 22psi atm and for a big heavy old slug they go well but for proper 60-130mph performance itll need a much bigger turbo, will also move the power band higher in the rev range, so for top end would be better imho. 19ts and k24s are better than the 16ts for power but depends what type of car your building i suppose. when finished my car wont be especially nice to drive every day but its not my daily, just a bit of cheap fun. as a daily 300bhp is plenty to play with and im sure suprises the uninitaited
so its running off the bcs at 22psi? who mapped that? take it your have a forged bottom end?
running a blitz dsbc and was mapped by a friend. standard (rebuilt) bottom end. it will eventually go onto a emerald k6, coil on plug ignition, 3 bar map sensor etc. this scurrent spec is just to smoke around in
Hi mate. Get these and turn up fuel pressure slightly. The can run 30-100psi and over 900cc at highest pressure.
http://www.ebay.co.uk/itm/Siemens-De...#ht_4199wt_821
Grey 855R Manual. Totally standard.
are they a direct fit for the t5 fuel rail? right length/thread etc? just curious as quite cheap compared the bosch no?
mitchyboy01 (Saturday 31st March 2012)
Deka's fit just fine, I have them in mine
do you run these then smithy?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks