Hey Chaps,
Im after some advice.
I am in the process of trying to replace the Cv gaiters on both side on my 855.
I have got to the point of getting the driveshadt not of from the wheel side of the hub but now I am trying to decide how to free up the driveshaft so I can get the gaiters on.
How do people do it?
Do you drop the wishbone down from the ball joint end or do you undo the two bolts holding the wishbone to the chassis?
I have heard that you jack up the wishbone to take the strain and then undo the bolts. is that correct? Is that the correct way of doing it?
Where do you place the jack? close to the chassis or close to the balljoint?
Cheers
Alex
Bookmarks