need a fmic for a p2 2001 s60 t5 ware will i get on e and r they easy to fit
cheers
roy
need a fmic for a p2 2001 s60 t5 ware will i get on e and r they easy to fit
cheers
roy
I was planning on getting one of these for my 850 (until the stupid thing attempted suicide), but you'd need to check measurements etc for your S60.
http://cgi.ebay.co.uk/ws/eBayISAPI.d...T#ht_733wt_776
There are plenty of places offering fmics so shop around. Forge motorsport (expensive but good), Bell intercoolers- T5monkey on here has one on his S40 etc etc
HTH
talk to tim williams, i have one of his front mounts and its a brilliant bit of kit. You can find him on this site
theres pics of my my car with a fmic being fitted by the above the guy. the car belonged to turkish when it was done
Bell are good but expensive, plus import hassle - get a UK one if you can! don't know much about S60 intercoolers.
BSR stage 3, BSR Stainless Exhaust, Vibratechnics gearbox Mount, OZ 17" Superturismo Alloys, Bell FMIC, LED Side lights, LED interior Lights, Tinted Windows, Eibach Sports Springs, K&N Air Intake, 3" Sports Cat and Downpipe, Debadged, EST Strut Brace, EST Grille, Black Moose Stickers, Bilstein B8 Dampers, Fully Polybushed, CC3 all round, CF Wingmirrors
Release the Monkey inside of you >>> Trunk Monkey
ok so do i have to take my car to tim or can he fab it and send it to me in scotland
think my car is gettin to hot round bout 5 and a half thousand revs drops off then comes back to life and goes to 7.5 rpm and pulls more
Im sure he can make it for you then send it up, but i watched him fit mine and its errrrrr well...... involved !
Mine runs at approx 15 degrees C above ambiant all the time, even under WOT and full load. On the dyno it hit 35 degrees intake temps, which is very very low for a dyno run intake temp especially on a warm day as it was.
hi how much does he charge for one
youll have to ask him. Dont expect to much change out of a grand.
Not sure if this will be relevant but when I had my FMIC fitted the ait conditioning condenser tray had to be changed for a smaller item as well.
Hard to see the inter-cooler in this photo but thought I'd post it anyway. Not sure where it was fabricated. (Got it off and fitted by GRN Motors....if you want details Chad can supply.....I can't even remember what it cost).
Any suggestions, information, complaints or grievances relating to this forum please feel free to contact us, talk to a mod or administrator
Cars : 2009 VW Passat CC 140 CR & 2015 VW Golf R. Uploaded Albums. Past Statuses (Or is that Stati?). Past Posts.
if i still had me tig welder i could of built you a custom ic. could of built it as a bolt on kit and popped in post for you.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks