Unsure on Setting Actuator up!

[MC_Bob]

How do you guys usually set them up?

Its a 98 PreME7 2.3 T5.

Is it just the usual half a hole business? Or can I pipe up a pump to see what values it should be at?

Ta!!

[t5 pete]

best way is to pipe a pump up i carnt remember the correct psi but im sure its around 3-4 psi

[MC_Bob]

What happens does the arm suddenly blow out?

[princepugh]

You might find the video in this page helpful:-

http://www.ipdusa.com/product.asp?st...hStartRecord=1

Think it mentions calibrating to base boost mid-way through?

[MC_Bob]

Ah cheers,
I cured my boost spiking by adjusting the actuator, now it wont boost as high as it did before!

Hmph. Is only around 2-3psi less, but the MBC doesnt seem to be doing anything.

[MC_Bob]

Cheers that vid helped loads. Set it up with a gauge I made, its ****ing awesome now, doesnt spike at all and is a shed load better.

Ta!

[princepugh]

Cheers that vid helped loads. Set it up with a gauge I made, its ****ing awesome now, doesnt spike at all and is a shed load better.

Ta!

Good stuff - out of interest what kind of gauge/ pump combination did you use? What pressure did you end up calibrating it to?

Ta