BT's latest phase

[JT]

no further questions your honour! lol

[p fandango]

get most of the front-end bolted together, hoping to get the bonnet on tomorrow (so its going to rain now)

[Jamest5r]

get most of the front-end bolted together, hoping to get the bonnet on tomorrow (so its going to rain now)

You wanna borrow my lawn mower

[p fandango]

You wanna borrow my lawn mower

thats the neighbours garden, ours is already concrete'd over lol

[T5RPete]

thats really quite impressive! It's going to be heavy with the bonnet on too though?

[p fandango]

thats really quite impressive! It's going to be heavy with the bonnet on too though?

its heavy enough as it is, still carryable by one person but its going to be a pain getting into place with just one person. At the minute i lift it from the headlight adjusters so not sure how i'm going to move it with the bonnet on lol

[T4Rick]

I'm planning to watch BT's first run up the strip, I wouldn't wanna see the engine fly out the top and make a mess everywhere lol.
Do you know what grade steel the box section stuff is? (you've been using a lot of it lately), please don't tell me it's the leg off a table or something lol.

Thats made my night hearing that Martin lol

[p fandango]

Thats made my night hearing that Martin lol

i've used a bit of old worktop to lower BT so its not that daft a question Martin asked lol

[T4Rick]

Are you serious lol

[p fandango]

Are you serious lol

erm yes lol

[JT]

he's always serious!! lmao
Ive seen the evidence!

[p fandango]

it'll be fine, whats the worst that can happen lol

[M-R-P]

it'll be fine

Pedro's new user title

[p fandango]

front-end still fits back on, 8 bolts holding the wings/bumper section on so very easy to remove. I'm tempted to leave the bonnet seperate for now

[T5RPete]

That looks do dam cool!! I think if it's going to make it awkward, then leave the bonnet separate!

I'm sure at any trackday you'd find someone to help but just on the off chance..

[p fandango]

That looks do dam cool!! I think if it's going to make it awkward, then leave the bonnet separate!

I'm sure at any trackday you'd find someone to help but just on the off chance..

i'll put the brackets on ready, just a case of doing up the nuts & bolts then once i've finished messing

[partsforvolvos.com]

leave the bonnet seperate mate. looks awsome .

then get a perspex bonnet made to show off all your hard work

on a downer, i just spotted the roof air vent thingy ...........

[M-R-P]

I can't help wondering how easy/cheap it would be to copy that front end in fiber-glass...

[p fandango]

leave the bonnet seperate mate. looks awsome .

then get a perspex bonnet made to show off all your hard work

i know you sold your Volvo, didn't buy a Saxo by any chance did you mate lmao

on a downer, i just spotted the roof air vent thingy ...........

i think it quite suits it, & certainly going to need some way of keeping cool inside lol

[p fandango]

I can't help wondering how easy/cheap it would be to copy that front end in fiber-glass...

already sorted