Safe psi

[stainesy]

once i have fitted my mbc what is i nice safe but fast psi to set it at?

[Wombatbomb]

And how are you going to tell the PSI? Remember, you're convinced your new boost gauge is broken.

[stainesy]

And how are you going to tell the PSI? Remember, you're convinced your new boost gauge is broken.

no its all sorted have new gauge all fitted and every fault on car has been sorted.

its all here mate

http://www.vpcuk.org/forums/showthread.php?t=17661

[jimka]

my bro has his set to 15psi, no problems so far

[stainesy]

so how do i ajust it? is it just a mater of ajust then drive and keep ajusting then driving till i get it where i want?

[irf]

yes.

[S70T5Chris]

so how do i ajust it? is it just a mater of ajust then drive and keep ajusting then driving till i get it where i want?

to be honest, if you don't know what ur doing. I wouldn't p*ss about with it. Ur gonna blow summit up!!!

[stainesy]

well iv just changed all my boost pipes and fitted a boost gauge. its not gona be hard to pull 2 pipes off and put them on the mbc. then ajust carefully wile checking the psi till it tops at 14. aint rocket science LOL

[stephenevans99]

aint rocket science LOL

oh dear....lol. Fatal last words !!!!! Be careful...please!!

[CONDYBOY]

My diesl v40 runs at 27psi, but I don't think you want to go that high, start off with the mbc screwed right out, then adjust a quarter turn between checks, when you get close to the pressure you want turn 1/8turn between checks then 1/16turn.....

You get the picture be carefull this could be very costly if you rush it, take your time and get it right.

[Nuckin Futs]

My Diesel V70 shows 20psi then flaps around 15-18 after is this normal?
and if I fit a MBC what type would i need?

[jimka]

That is normal for a diesel... mine use to boost 30psi on overboost. settle back at anywhere between 26-28. (mine was a 115bhp s40 model)

Nice username by the way - I have a T-shirt that reads the same