Originally Posted by
Ron@iPd
I’m not sure if I can shed some light on this or not but I thought I would chime in. The iPd TCV is by no means a performance adder. It was designed to replace a potentially failed or worn stock valve. What makes this a heavy duty you ask? The valve operates at a higher frequency so it can control boost more accurately. The finer the adjustment the more precise the boost control. The valve can be opened and cleaned periodically as they can and do get dirty with oil and debris. This is something you cannot do with the stock valve nor an AC Delco or many others for that matter. This is a unique feature we wanted to keep the maintenance costs down on the unit. This means the valve works faster, more efficiently, and can be serviced. These are features that cannot be found on any other TCV. There can always be a less expensive replacement part found but the reality is, if you have to replace the same part over again, doesn’t it make more sense to get one that can be serviced?
The second topic is what is referred to as the learning curve. This is because the stock valve operates at such a lower frequency it can take the computer time to learn the operation of the new valve. What normally happens is the system uses the stock mapping to control the new valve and can cause it to over boost. When this happens the system goes into what I call ‘limp mode” or lower duty cycle. For instance, if the old valve was maintaing boost at 85% duty cycle it will run the new valve at the same frequency. This can cause the car to over boost and when this happens the system will go into limp mode. Meaning, the system will override the factory settings and operate off waste gate pressure only. When the vehicle begins the new run cycle, the system will lower the duty cycle to say 10% and is essentially “learning” at this point. If the system sees an under boost situation, it will then change the duty cycle to say 80%. If there is still an over boost code it will then lower it to 15%. It will continue this until it brackets the correct duty cycle to maintain the preset boost pressure as per the ECU. I may be late to the table on this but from what I read, this maybe should have been address in the beginning. If anyone has any questions at all please let me know.
Bookmarks