Turns out my Walbro has given up! Only fitted it 3 months ago :-(
Type: Posts; User: Nico20V; Keyword(s):
Turns out my Walbro has given up! Only fitted it 3 months ago :-(
Is ok once it gets going but hesitates and judders accelerating from low revs in each gear. Can rule out fuel as does it with LPG & unleaded. I'd expect worn clutch to exhibit wheel spinning type...
Since I've got variable speed intermittant wipers now, this issue with the steering wheel is my last niggle. I had a lovely wooden one on my old 850 and a nice thick leather one on the C70 I had...
Has anyone some detailed guidance on this please? thanks
Your most likely cause by the way, is simply worn drop links. dead easy to do yourself. Bout £30 each. Just need wheel off.
Same again here. Ordered new top mount from volvo (about 30 quid) and was guna swop myself, but then MOT came back with worn swing arm bushes too. They have persihes quite badly and are less than a...
Halfords ready mix is only good down to -4C. If you buy the better stuff for a quid more , even at 50% is still good down to -17. Full strength allowing for windchill and its good to -34, so no...
By IPD endlinks, I take it you mean drop links? I recall some debate on here recently about them as people were struggling to source. I was guna get hold of a set too but my scamtech havn't given up...
Hi Doc! I have to say that I expected little difference on the front and I didn't expect to find a stock ARB on the rear, so that too meant I might not otherwise have deemed these a worwhile mod...
So what's good and bad incidentally in terms of battery output incidentally?
In layman's terms I would have thought all batteries came close to but did not exceed 12V, and higher amps would be best...
Cheers guys. Incidentally (for those that have fitted a walbro and run a seperate feed to it|) do you reckon its easier to run the wire under the car if there is some point or seal through which I...
appreciate the added direction Al, but can you elaborate more at all onthe 'pushing collar' whilst levering in opposite direction? You mean baically just push before you pull?
'Screwdriver to help lever up the fuel pipes
A blunt punch to start turning the locking ring'I'
I've benn putting this off for weeks cos its so bloody tight! Getting any leverage is nigh on...
Similar dilemma myself at the mo. Had bought some Castrol Syntrax Universal 75w-90 but then Rufe suggested I needed 5w-30. I checked with dealer and they swear for my car its their (I think its)...
I thought the exhaust on my 97'v70R was in pretty good nick but closer inspection and I found a hole had rusted through at the join of the pipe on the rear of the silencer.
For stainless steel...
Where are MIJ and what did the exhaust set you back?
I just installed my stepper gauge last night. It had a sender so need to connect the vacuum pipe through the cabin.
Regards the wiring (mines P1-97'V70) my harness had four wires - ground / live...
mmmm...very interesting. It's not something i'd been keen to consider on grounds of cost, but that is a significant drop temp. As a started can you give us a quick breakdown on the costs of the S1...
Surely not. The majority would come from block and exhaust manifold.
Be interesting so see what the temps come out at when you get chance fandango.
mmm. have been reading wilkipedia on workings of a turbo and I've not perhaps allowed for just how hot the compressed air must get once it leaves the turbo. I would have expected it could perhaps...
Of prospective interest for anyone with turbo silicone hose upgrade and/or induction filter I guess…
Ok so I'm a newbie and a novice but is my reasoning sound on this one? In an earlier thread I...
As title really. I can here it and can feel it through the pedals. First I thought it was exhaust hanger gone and then replaced worn droplinks after ruling out exhaust and still doing it randomly....
I've got some 18" RS3's in mint condition I'll be auctioning when I can be arsed. I liked em on my C70 but not for my safffron V70R. V.diffrent to the pegs but that's why i like em ;-) I'll post a...
Well i got some from PFVS online after assurance from Gavin they would fit my 97R and they won't. The ones supplied supposedly to fit 97-00 models came with fins top and bottom to fit into a rebate...
I seem to have a similar problem. Each of my T5s has been prone to wear on the inside and my v70r seems to be prone to it on the rear too. No matter how times I have my tracking done, it seems all...