Search:

Hello,
Assuming i get my scando bentley working (fuel pump) wheres the best place to get it MOT'd and repaired in or around Southampton? Anyone have any ideas? I've used Hampshire Volvo specialists...

Nice....ish. good job. Shiny, shiny, shiny engine. Now jealous. Er. Much more jealous-er.

Can they dip entire cars yet?.......

I'm in a slightly similar position - everyone and thier dog is telling me to ditch the retardis as its burning/leaking oil and I've spent too much on it just getting it running right-ish but............

On a serious note though - if you've got loads of room etc then I would keep it.

Dont sell it - swap it for my piece of crap, auto T5 estate - I'll drive everywhere with a massive smile on my face and you can drive around with the "is it the head gasket or isnt it?" Face on and...

Hello, just as the title says, in the last six months I've had him, a new job and no time for either here or the vine inn!

Last Friday I called In a favour and got Chezzer put up on some ramps at...

Saturday being dyno day? I'm working on it, but with a new baby and stuff I'm not committed 100%.
Are there still places left? I'm very curious to see how many moose are left in the T5! More to the...

Fixed it on Sunday! Changed the thermostat and did a flush and coolant change. All seems okay so far...

I had a noisy coil in mine - it was so loud you could hear it over the radio! Local Indy ran checks on it and said it was fine. I replaced it anyway with an OEM one. Nice n quiet now.

There is something in the air - mines in again as well. I usually just wait fir it to go off after a couple of days if driving lime miss daisy. Everytime I drive it higher than 2500 rpm when it's...

*trying to say nice things, but just being sick with envy*

Well done, hope all is good...............I would just like to state, for the record, that I am very, very, very jealous!

That is all.

Nope. Still jealous, even more now.....!

Right - we left her to idle for a bit and then held the revs between 1500 - 2000 rpm to simulate a short drive. The temp then then crept up to 3/4 and then suddenly rose towards the red. We shut the...

Right....the temp gauge normally sits at 3o'clock, exept for the last two days its been hitting too close to the red for comfort! I've got water in the header to the max line, no gunge in the oil and...