Join Today

Search:

Type: Posts; User: Gaz; Keyword(s):

Search: Search took 0.01 seconds.

  1. Thread: High fuel pressure

    by Gaz
    Replies
    7
    Views
    8,683

    Hi the lines are definitely on the correct way....

    Hi the lines are definitely on the correct way. Could a blocked evap system cause high pressure?

    Sent from my SM-G960F using Tapatalk
  2. Thread: High fuel pressure

    by Gaz
    Replies
    7
    Views
    8,683

    I didn't check it before changing the pump...

    I didn't check it before changing the pump unfortunately. This has come to light after doing some logging and the fuel trim is too rich which is causing it to lean out at the top end. So this started...
  3. Thread: High fuel pressure

    by Gaz
    Replies
    7
    Views
    8,683

    So the vacuum line is absolutely fine. I have put...

    So the vacuum line is absolutely fine. I have put in an adjustable high flow replacement fpr but can't get idle pressure below 4bar. At an absolute loss as to why this would be happening. Injectors...
  4. Replies
    86
    Views
    45,104

    Exhaust manifold gasket? Sent from my SM-G960F...

    Exhaust manifold gasket?

    Sent from my SM-G960F using Tapatalk
  5. Thread: High fuel pressure

    by Gaz
    Replies
    7
    Views
    8,683

    High fuel pressure

    Hi folks, I'm getting a high fuel pressure reading at the rail on my 1998 v70 t5. It is 65psi at idle but 43.5 when just primed and engine off. I have fitted a new fpr and checked return line for...
  6. Replies
    86
    Views
    45,104

    Yes this is what I suspected. I would change it...

    Yes this is what I suspected. I would change it for a properfekt one it really is a huge difference. As suggested you can bend the tabs to apply more pressure but you will be doing it again in no...
  7. Replies
    86
    Views
    45,104

    Pressurise the vacuum line on the cbv and if it...

    Pressurise the vacuum line on the cbv and if it doesnt hold pressure you have your problem

    Sent from my SM-G960F using Tapatalk
  8. Replies
    86
    Views
    45,104

    The cbv outer edge works as a gasket. It is a...

    The cbv outer edge works as a gasket. It is a poor design and 99.9% certain it is your problem especially after seeing what look like very good condition turbo internals.

    Sent from my SM-G960F...
  9. Replies
    86
    Views
    45,104

    I had a very similar issue and it was the cbv...

    I had a very similar issue and it was the cbv valve. The diaphragm was intact it was infact boost escaping between the mating surface of the turbo and valve cover. It is a poor design in my opinion...
Results 1 to 9 of 12
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.
     
ipv6 ready