Search:

Thanks for the replies

Is it possible to blank off the recirc valve on my remapped t5 without fitting a dump valve? Will it do any damage ? Is there any more to it than romoving the valve, fitting the plate and blanking...

Thanks, just sent you an email

Was looking for 302 carriers for a while with no luck, so I decided to go for the 320 upgrade instead.

I think I have everything i need other than the brackets, I know dvs performance sell them...

no luck at the dealers, cant seem to find any anywhere.

I'm looking to do the brakes on my t5, does anyone make the carriers or know anyone selling a set?

Thanks in advance

Thanks for the responses, I'll probaly just secure it up out of the way, doesn't seem to be affecting anything on the car as is

Was having a blow in my exhaust repaired, while on the ramp I noticed this plug hanging down at the front drivers side, any ideas what it's for/where it should be?...

I've started to notice a bit of clutch slip at peak boost on my t5, nothing too serious at the moment but its making me think about changing/uprating it.

so what's available in terms of uprated...

after some comments on here, i'm going to give my actuator 1 turn on here to up my boost a bit, now i know how to do the adjusting, i just cant see how to do it on my 850, theres a heatshield in the...

theres nothing wrong with manual boost control, as long as its set up right and not played with.

That's my job for tomorrow sorted lol, I was going to get a bleed valve for it and up the boost a touch that way, I assume this will have the same effect?

Excuse the noob question, I'm kind of...

as above, ive just fitted a 304 ecu myself, the boost gauge should be well over the gauge, on a fifth gear pull from 60, mine was about 1 or 2 mm from the end of the gauge

i put a tme back box on mine, gave a more noticeable burble, not too loud, juts a tad louder than standard. i then teamed that up with a decatted front pipe, and that has made it sound really nice,...

wheres the best place to go through the bulkhead?

im looking to put a boost gauge in my 850, ive got the location sorted, i just need to know where to tap in to, ive dropped the trim panel above the pedals and theres a few pipes that it could be, i...

the lens of the headlight will dictate where the beam shines

The car was looking well today mate, get the small issues ironed out and it will be a cracker.

Thanks again for those bits.

ive tried that in the past, but it never seemed to last, i used a heat gun in the past as well, but it still needed topping up with one product or another.

this stuff is supposed to last a while,...

ive been looking for something good for a while to restore the exterior trim parts back to an original state or as close as possible, I've tried a few products over the years and i think ive just...

as above look at the other cars of similar spec/mileage and price yours accordingly.

the thing you need to think about is how long the cars advertised have been for sale at that price, then think...

lol yes, but looking at your sig your car's probably a lot more modified that what mine will be, im just looking for basic bolt ons from similar volvos that will give me a a little performance boost.

im still on the look out for tuning parts for my 96 850 t5 estate, was wondering what other cars use the same set up with regards to the exhaust intercooler etc.

would a 98 s70 exhaust fit mine?

theres one on ebay, thats off an auto 850 r and its got a conical end on it by the looks of it, so you could be right

It's a 96 n reg