Search:

ok, thanks

hi all, is there any way i can advertise my car on here with only having 71 posts? thanks

got the mbc fitted today and with one turn its now running 0.9 and peaks at 1.0 bar with no issues. so much better :) next step remap and custom exhaust :) or yeah and a bailey dv.

thanks, where is he located?

yeah it is, i think i read about them on here so made sure i got ball and spring one.

just bought an mbc so will see what happens when i fit it :)

thats the plan :)

thats not to bad. i want some 18's but volvo wheels seem to make a bit second hand.

its a 98 on an R and isnt an me7, it has a throttle cable.

that sounds good and a good price too, will look into it. thanks

hlm are a bit far away from me, im up north.

sounds good. i will get a remap when i can afford it (just spent a fortune getting it through an mot) do you think it will run 1 bar without the fuel cut kicking in?

i like the look of st wheels just found some jag ones that are cheap. do you no how much it is going to cost to have them machined out?

it isnt an me7. i was hoping to get the boost closer to 1 bar, it runs at 0,5/0.6 bar now.

did the ford wheels fit without any modifications?

hello everyone. is the standard bov on the turbo housing? im going to fit a bailey dv26 and think i need to blank off the original one.

im also thinking of fitting a manual boost controller but...

thats what i was thinking, thanks

thanks. so with the bore bigger on the volvo they wont bolt on?

hiya everyone. will jaguar wheels bolt straight on a c70? i no the pcd is the same but unsure about offset and bore. thanks

Yeah just a bit. Plenty time though :)

No, I would of if the last owner hadn't gone crazy with his angle grinder lol

The one's in mine wont pass an MOT. The garage will change them for me, I just got a shock when they told me how much it was going to be. Not only has the arb been cut but the last owner lowered it...

Have you replaced the rear bushes before? I got a bit of a shock at the price of them, and i need two lol

That would be great, thanks.

There is no wires going into the switches, last owner took them out for some reason. It looks like a challenge doing any wiring with the seat where it is. Thanks for the info.