Printable View
Hi again guys my v70 T5 is doing bit hunting when idling, I went to try and clean the maf sensor after reading up on it on here, I can't get it off at the jubilee clip end, is there a knack to it? Pretty sure after reading that's this is what the problem is I may just buy a new sensor anyway where's the bestsellers or even better anyone got a spare lying around?
Thanks in advance guys this forums been amazing in the past :)
there is no knack mate just rip it out you need power that's it when its off give it a clean with some contact cleaner. if that doesn't work try cleaning your etm its a pain to do if your not handy with the tools but its a big one out the way.
MAF is held in by one or two torques screws. Then sealed with a very soft O-ring. It will prise out quite easily.
He means 'security torx' not normal Torx screws. normal Torx won't fit.Quote:
Originally Posted by JUDGENINJA
Get yer self down ECP's and buy a set of 1/4" drive security torx sockets set for £17. Then you won't have to bugger about trying to undo the jubilee clamp all the time. Much quicker and easier, as JUDGE says, easily comes out.
Just had same problem with mine a few weeks ago, ended up replacing MAF with a new Bosch one from PFS
Morning guys git myself an obd bluetooth thingy an hooked it up to my fone the following codes came up p0573 and p0014 now a quick look here gives me camshaft sensor as p0573 and brake circuit? as p0014...what do you guys think my plan of action should be? I'm back at work so it's probably gonna have to wait until the weekend unless I get a spare few hours one afternoon, hopefully it's pretty straightforward and I can do both jobs at once :) thanks in advance guys...
P0573 is Brake switch "A" circuit high.
P0014 is Cam Position Activator B, Bank 1, Timing Over Advance.
Both are a little double Dutch to me, what action is needed or will it have to go to a garage?
Do your brake lights works?
I would clear the codes and drive for 50 miles and see if they come back.
Brake lights are working tho I did have to replace the bulb holder last week, I'll clear the codes before I drive hone from work an check them again in the morning, thanks Lee :)
You need to leave it a few days before re checking codes. At least 50 miles driving.