Well thats what I had intended to do. But the doors didnt come with hinges anyway, so have had to put them on whilst im holding it up.
The loom came off alot easier then going on. That was a pain.
Well thats what I had intended to do. But the doors didnt come with hinges anyway, so have had to put them on whilst im holding it up.
The loom came off alot easier then going on. That was a pain.
Contacted, sorted. Awesome.
Cheers, yes it was nice. It seemed like it had happened to here alot though. Her husband came out to say, yeah sorry, we've already called insurance.
Also I got my radio code from the guy on volvo...
Fresh MOT on the zed after 2 front tyres
http://i.imgur.com/EQP2M08.jpg
Got my volvo back and sourced a pair of wings and doors (doors being replaced because of corrosion at the bottom)...
Bent the exhaust forward coming off a kerb and then my car got hit
http://i.imgur.com/2E9LmLT.jpg
Eventful Saturday afternoon.
Was left a nice polite note admitting full responsibility,...
This is old so I assume you have done this now. But I used the coil spring seat and both parts of the top mount bearings, after trial and error after fitting just one of the bearing plates.
No problem, the bits on it were well worth it. It wasnt to bad tbh its just cheaper to put it all in a new car than to repair.
Thats a good shout actually. Ill look into doing that as i do feel im letting pressure escape somewhere.
Jamesy thats a different zed haha. I was running low 14's at pod the other day. The last...
I think it will fit. :D
Ive got 2 clios begging for new engines :D
My starter
http://i1111.photobucket.com/albums/h472/sparkysparks1/Mobile%20Uploads/WP_20151028_15_54_44_Pro_zpskrutisfm.jpg
Still needs putting into a hole properly, but for now working...
Its switching the polarity of the crank sensor for a good start. Saves me taking the gearbox out and finding an OBD1 flywheel.
My carefully selected DPDT momentary switch arrived
http://i1111.photobucket.com/albums/h472/sparkysparks1/Mobile%20Uploads/WP_20151025_11_11_03_Pro_zpspeysbj99.jpg...
Hes loving the clio btw. Im yet to see it haha.
It doesn't seem to matter how long its been prepping itself for or how long its been on ignition for it still starts the same way,
Ive not checked the filter actually, ill check on that.
He passed. Just about. So time to tax it
Clutch bled again. I think I had left the slave nipple loose causing the pressure to go.
New lambda probe installed.
Starting issue cured. Hooray!
It was the ignition coil/amplifier. Car bow...
I had issues like this then eventual bad running and cutting out on my 480 when a 12v cable to the battery decided to get damaged and burst into flames.
I would suspect a dodgy battery or wiring on...
Ok some great info here, thanks guys. Ill take it all on board. Realistically if my car performs well and I'm happy with the power its at I wont do anything to up it and leave the boost controller in...
I am fully aware of how turbo cars work. I'm just new to t5 engines. I've not got the knowledge base of what's achievable yet.
Well it does need sorting so hopefully if thats the problem it'll be all good after a fix.
And about the bhp claim. I even said to the seller. I don't think so. But it'll still be quick
Time to take the tints off
http://i1111.photobucket.com/albums/h472/sparkysparks1/Mobile%20Uploads/WP_20150714_18_02_08_Pro_zpsbgg5nl5v.jpg...