Assuming you have fixed it by now...?
Firstly your car shouldn't be idling at 750rpm. It should be 850rpm. secondly i had exactly the same problem on my car when i first got it. Software flash is...
Assuming you have fixed it by now...?
Firstly your car shouldn't be idling at 750rpm. It should be 850rpm. secondly i had exactly the same problem on my car when i first got it. Software flash is...
Assuming plugs are good and there are no other leaks, I'd get the throttle body cleaned.
Can of petrol and a box of matches?.
The two sensors in question are the ones directly behind the radiator fan, on top of the black hose that goes from the intercooler to the throttle module, the black pipe is just below the inlet...
You don't need to disconnect the airbag but you will need to be very careful. You can pull it out enough to undo the plastic retaining clip thats in there. The dealer will cut this and fit a new...
This one ?
Something like these ? :-
http://www.dsldevelopments.com/sitegfx/Brodit_Images/610850-4.jpg
Search for your car at www.dsldevelopments.com. There are a wealth of mounting solutions for all...
The abs rings are about £27 each from volvo i think,rufe will be able to give you a precise quote but you do need to inspect them first,if they are cracked then they will have to be renewed but if it...
When you start the car the system self checks and the lights should go out,as they are going out on your car this rules out the sensors,when you hit 15mph it self checks again and on your motor this...
Here's the sensor connection just above the socket/ratchet.
http://i97.photobucket.com/albums/l204/s60mbs/car/P5010185.jpg
Its a relatively simple job, locate the plastic 'button' clips around the edges of the door card and press the centre of them in positively. Next use a thin & wide flat blade screwdriver or similar...
I do agree that it would be hard to prove, but if it had happened before we found this mistake out, we would have had an entirly different post on the go.
One where, in all likleyhood we'd be...
I'm not sure what you mean by 'on the leg of the arm that doesnt carry the lock stops there is a moulded lump' - I can't see one on mine and can't see any on those pictures I linked to earlier.
...
Having done the wishbones, I can't honestly see how you'd fit them incorrectly. The front and rear fittings are completely different.
This is the only serious post you'll get from me today!
Installation linky
This is what I have in mine plugged into the cd changer plug on the back of my HU803. So I can't use the boot changer anymore but doesn't bother me.
...
You could use something like this, i believe they have a european distributor
http://www.volvotech.nl/index.php/cPath/102_14_44
Don't have an answer but maybe a couple of pointers.
"Lock stops were new with the new lower arms (not volvo) although the arms measure up exactley the same size".
So the lower arms (wishbones)...
Could be a duff shock, it would give a bad feel to the car through frequency vibration/road surface ripples.
Has it only happened since the change to the front end? If so, then all the bits on the...
Also check the inner steerring track rods (the one that pivots with the suspension inside the rubbber bellows on the steering rack) as this is a known weak point. I am on my second replacements in...
If you're getting rub on one side and not the other, check the stop locks that are fixed to the lower wishbones. One could be knackered, the other ok. This assumes of course that you have the same...
I get this too. What size are your wheels out interest? Mine are 18's with 225's on. Sorry can't help with the other issues as I am a little bit dim when it comes to anything more technical than...
Just finished the latest batch of 'bones.
This is what they look like when I get them.
http://i33.photobucket.com/albums/d55/shedbike/various119.jpg
Stripped, inspected, polybushed and...