Join Today

Search:

Page 1 of 2 1 2

Search: Search took 1.00 seconds.

  1. Replies
    14
    Views
    23,606

    Thanks for that Claymore Have been busy lately...

    Thanks for that Claymore
    Have been busy lately and have not had time to do much a quick update
    the main problem i had was a gear box ratio fault due to the diff ratio the jag was a 3.06 and the...
  2. Replies
    1,271
    Views
    456,608

    That should stop it popping off, nice solution...

    That should stop it popping off, nice solution Colin
  3. As well as Ovlov I also have a second project...

    As well as Ovlov I also have a second project which is milking me dry haha

    I wanted to race so am competing in some Sprint racing in this I have been building:
    ...
  4. Replies
    23
    Views
    12,633

    Chips! TLAO ran over 400bhp on them, that's fine...

    Chips! TLAO ran over 400bhp on them, that's fine for me for a start. Eventually I'll be looking into MS, I think someone does a plug-n-play job for LH? Not sure what to do on the clutch side of...
  5. Replies
    182
    Views
    65,359

    All ready ahead of you the oil filter will be...

    All ready ahead of you the oil filter will be fitted with a sandwich plate then line to a external oil cooler.
    The water pipe tha runs along the block is a new n/a one as no longer need the extra...
  6. Replies
    182
    Views
    65,359

    You not done this yet? Jesus, Smithy will be...

    You not done this yet?

    Jesus, Smithy will be done before you at this rate.
  7. Replies
    182
    Views
    65,359

    Jays car has been running reliable for ages now...

    Jays car has been running reliable for ages now and it's his daily lol.he uses a 25 litre fuel cell with twin Bosch 044 pumps .his car has got a hx40 super with billet wheels and twin external...
  8. Replies
    182
    Views
    65,359

    Don't be daft. Pete would never lower himself...

    Don't be daft.

    Pete would never lower himself to being sponsored by Pukka Pies, the pale southern imitation of a proper northern pie like Hollands!
  9. Replies
    182
    Views
    65,359

    Coordsport do the stuff for the redblock mate .i...

    Coordsport do the stuff for the redblock mate .i got wesco pistons and rods from them for mine
  10. Replies
    22
    Views
    9,029

    Ill be starting my 940 project in next few...

    Ill be starting my 940 project in next few months, I'll post up some brake pics when I'm fitting it all up.
  11. Replies
    28
    Views
    6,159

    You'd be better off using a hiab... ... To...

    You'd be better off using a hiab...

    ... To lift it into a skip :)
  12. Replies
    23
    Views
    12,633

    Sorted that for you :)

    Sorted that for you :)
  13. Replies
    1,271
    Views
    456,608

    Or 1/2 mile

    Or 1/2 mile
  14. Replies
    182
    Views
    65,359

    He'll get the Galaxies! Lol

    He'll get the Galaxies! Lol
  15. Do that with a Manc around and it won't be...

    Do that with a Manc around and it won't be outside your place for long ;)
  16. Replies
    27
    Views
    7,682

    Smithy has one that hes never going to use.

    Smithy has one that hes never going to use.
  17. Replies
    34
    Views
    10,545

    Good luck. Mine didn't take long to slip, but...

    Good luck. Mine didn't take long to slip, but then Smithy's lasted years...car hasn't been on the road for year though..lol
  18. Replies
    22
    Views
    9,029

    I'm aware of that as I made a set up for a 740...

    I'm aware of that as I made a set up for a 740 turbo as pictured above using 25mm wheel spacer. You'd never get 336mm 4 pots under 99% of 17" wheels inc Polaris as there offset means they run close...
  19. Thread: My 940's..

    by jks
    Replies
    78
    Views
    13,213

    With std springs, which limits the front wheel...

    With std springs, which limits the front wheel width, you can run 8,5-9 fronts, rear you can run 12, with right offset.
    With coilovers on front, I recon you can run 10's, with right offset.
    On a...
  20. Replies
    185
    Views
    80,203

    Been going through the bin files over the last...

    Been going through the bin files over the last few evenings and have found a "launch control" file :)

    Hope to copy this file over to the map that I flashed onto the ECU at the weekend :)
  21. Replies
    201
    Views
    46,242

    I picked a focus box up for £50, can't remember...

    I picked a focus box up for £50, can't remember who I sold it too
  22. Replies
    48
    Views
    14,926

    looks cracking for an ornament :uglyhamme

    looks cracking for an ornament :uglyhamme
  23. Replies
    977
    Views
    174,901

    Good to see you've made a start Pete, maybe it...

    Good to see you've made a start Pete, maybe it will be finished before smithy's 940 :hidesbehi
  24. Replies
    23
    Views
    9,355

    Probably more than you've been in your own!!! ...

    Probably more than you've been in your own!!!

    Looks a Sweeeeeeet ride thou
  25. Replies
    42
    Views
    4,211

    picked these up today from the refurbers just got...

    picked these up today from the refurbers just got to order spacers now .they are not deepdish but should look ok when on the car though
Results 1 to 25 of 31
Page 1 of 2 1 2
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.
     
ipv6 ready