It is under the drivers seat if you have the 803 model (multi-disc) and it's built into the set if you have the single disc 603 model.
It is under the drivers seat if you have the 803 model (multi-disc) and it's built into the set if you have the single disc 603 model.
Hi Kevin,our full details are in the traders section and on the voc site:)
Paw prints add character,besides,at least while the cats are there the mice wont be coming in and chewing through your wiring harness :)
No panic,just come over and fit one,if you cant trust a mod who can you trust.Sort me out when you're ready.Not the sort of job to leave really,nothing worse than trying to get the antifreeze dried...
Hi Owain,if your going this route make sure you dont go and buy a de-catted front pipe for a t5 as it wont fit.You will need to convert your original front pipe and cut the cat out as the awd...
Not that much tc,yours for £25.You can even change it here if you want in case you hit any snags.
Adam.
Hi Alistair,there are two problems that can cause this set of symptoms that we have come across,one is what we call"lost compression syndrome",basically the rings stick into the pistons for no good...
The abs rings are about £27 each from volvo i think,rufe will be able to give you a precise quote but you do need to inspect them first,if they are cracked then they will have to be renewed but if it...
When you start the car the system self checks and the lights should go out,as they are going out on your car this rules out the sensors,when you hit 15mph it self checks again and on your motor this...
If your coming over for the matrix job i'll give you one foc.
Adam.
Just a thought Paul,but have you checked the bolt that holds the engine stabiliser bracket to the bulkhead,i have known these to work loose resulting in a noise such as you describe.
Adam.
Hi,you need to undo the four torx screws that hold the fuse box cover down(at the base of the screen on the o/s),the relay is under there.The fuel pump relay is marked as such and is pink,about 1"...
Hi Lee,you dont need to undo the shaft,i just undo the track rod end to allow better access to the pinch bolt on the balljoint but even this is not strictly required.Just dive in there and unbolt the...
We stock most Volvo bits secondhand,give me a call or pm with the sensor number and i'll check and see if we can help.
I did get rubbing on the rear n/s under hard cornering with mine when i fitted orestes (same size as tethys) with 215/45x17 avon zzr's,i decided that the r/n/s axle bush was allowing a small amount...
As above really Cameron,my wheels are off the newer shape V70 but with the 215/45x17 tyre size on and they do rub on full lock.I ignore it and dont use full lock!
They are Tethys.100%. Most commonly fitted to S60 2.0T and some T-5 S60's.Not usually found on V70's though unless fitted "post showroom".Look nice on the 850,i had a set on my old 850R and they...
Well,you need to decide whether it's a job you fancy attacking yourself or not really,if not then you need to be looking around for a local volvo specialist to do the job.A general repair garage...
I've heard jag wheels fit but i've never tried any myself.Might be worth enquiring though !
Hi,clutch drag is the most common cause of this symtom and usually shows in reverse initially and then graduates to being a problem in first and second.Can be caused by the clutch plate sticking on...
out standing bit of fettling to create that rig,i will certainly be sending some your way in the near future.Well done!
We have fitted used units in the past without problems,we just make sure we match the part no's to the oringinal.If you wish,you can pm me the ecu no. (you will need a mirror to read it as the label...
They should look ok on the 850,they are 16" off a low spec C70.The metis are not pretty,we have plenty of them,they would need a different tyre though as they normally have 215/55x16 fitted and you...
We have fitted good used modules to the S80/S60/V70 range without any need for any software download.Rufe will be able to confirm whether there is a software patch available for this vehicle but i...
Hi,i believe these were made for the canadian market and the emissions were the reason.They did a similar thing with the normally aspirated 2.5 engine(pre me7),this also had a recircualtion valve...