mine was using about half a pint a week for months , then i noticed there was oil in the water res and it gradually got worse until all the water ran out the broken the radiator , since i fitted a...
mine was using about half a pint a week for months , then i noticed there was oil in the water res and it gradually got worse until all the water ran out the broken the radiator , since i fitted a...
They look good to me in the silver against the green
T4AL was breaking an olive green v70 not long ago, he might still have some bits?
keep an eye on all the forums mate peeps breaking 850s all the time or just get them sprayed and use cans mate
sorry mate but i dont do pink slips i will beat you and i will take my car home like you will be taking yours home mate and jamest5r will be he will be carrying a portion of my kids mate othyerwise...
the centre large hole where the badge fits. pop the cap off and the recessed hole will need a mm removing so that it fits over the wheel bearing
bore size will be too small, you'll need them machined out
a decent machine shop should be able to do this for not too much.
otherwise should fit OK
Think volvo offset was 43mm and the bore is 65mm?
Would just need the bore opening up which any decent machine shop can do.
Try Readview in Accrington, they are very good and have an extensive range of parts.
Have look at this thread- pics etc on it. If that's not enough just do a search for mbc threads- plenty of them! HTH
http://www.vpcuk.org/forums/showthread.php?t=34434&highlight=mbc
9-10psi is about right for standard. As for which boost controller is best depends what your after, if you plan to do quite alot of mods then an electric boost controller will be best, other than...
Are these the guys in Preston?
RICA in Preston
Obviously the power gain figures stated have been 'mildly exaggerated' as discussed here on the odd occasion.
I had the RICA280 on mine and I...
Thats not a genuine Mitsubishi turbo though. Kinugawa turbos make their own units. They do use genuine parts in some but most are sourced and built in their factory. JAWharehosue use and sell...
Not sure, but I think Alanm has used that company for bits n bobs and iirc they're ok. Might be worth dropping him a pm mate.
I've had a TD04 rebuild kit from that ebayer before, had no problems so far
I know what that feels like!! lol
Changed :)