It's out of an 850 so i would guess so, ill send it to you and if it works pay me if not send it back. Ive got to get to a post office tomorrow to send a few parts off so pm me your addy.
It's out of an 850 so i would guess so, ill send it to you and if it works pay me if not send it back. Ive got to get to a post office tomorrow to send a few parts off so pm me your addy.
Ive got a spare switch if you want, £12 inc p&p :)
http://www.vpcuk.org/forums/showthread.php?t=24716
Found is a lot easyer to get at the bottom bolt from underneath.
Step 1
Take off the vac pipes to the recirc valve and waist gate, also undo the clip for the boost pipe and move it out of the way...
Halfords mate- decent pro quality tools that last a lifetime; get a decent 10mm ratchet, you'll end up using it a lot on your ovlov on other jobs :)
I know you would have seen my PM by now, but a reminder to others that we can find the radio code for your vehicles, absolutely no charge.
Simon :)
Hello fellow VPCUK-ers,
I was thinking of a way to give a little something back to the VPCUK community, which has been so helpful to me over the last few years - particularly recently with my...
This is more than likely to be the shock absorber bush mount, a common problem apparently. As Alan M says if you remove the floor covering in the boot where the shock absorber to is you will be able...
I would first check your strut top mounts. They are visible by removing the flooring in the boot area. They should be in good condition and one piece. If they are okay it may be more than likely...
What car is it Daza? An estate or saloon? It could be one of a few things, worn top mounts, rear bushs or outer bushes worn or even the rear struts may need attention.
http://www.jdmperformance.co.uk/item_detail.php?prodID=449006460
Much better at releasing seized bolts if you can get hold of some !
4 bolts. 2 x 17mm (i think) bolts that need removing from under the rear bumper, best using a hex socket as they will probably be rusty as hell. Very tight also, plenty of wd40 required!! 2 x 10/12mm...
You could also take a feed straight from the vacuum tree saves inserting a T piece.
Under the dash to the right. You will need to tee into the hose for the dash gauge and run your new hose up through the steering column and through the underside of the plstic where you want the...
:icon_soap
Hi chaps,
Just done my heater matrix myself cost £122.00 for the matrix and 2 new "o" rings for the rear heater pipes from nordic car parts
You need to be a VOC member to benifit...