the early 760s had a prv v6 motor that was crap so trey designed a straight 6 motor for the early 960 in 12v form and the later 1s were 24v motors the later had the 3in tb on them that is what have...
the early 760s had a prv v6 motor that was crap so trey designed a straight 6 motor for the early 960 in 12v form and the later 1s were 24v motors the later had the 3in tb on them that is what have...
its off the 3.0litre 960 but thought it was a straight 6 tbh, again i don't know much about the 900 so Tomcat or Smithy would be the one's to ask
Yep, TC is right, it is screwed to the bottom of the abs pump. Behind the airbox on the n/s strut tower, there is a connector you have to unclip and lift to disconnect it. Its bolted on with 4 torx...
I would imagine it'll be in the same place as the later T5's, it should be screwed to the bottom of the ABS pump (It's flat black box).
ideally you want the injectors to run at a maximum 80% cycle duty. Whites or possibly blues if your running alot of boost along with other mods on the 16t
Off the shelf remap should give around 235bhp (assuming basic parts are up to scratch)
16T (direct bolt on), remap, exhaust, bigger injectors and performance filter will give you around 285bhp...
Yeah, you can get a remap on the standard turbo to around 230bhp, I'm running just an mbc at 10psi. You can go bigger turbo, injectors, remap and exhaust for about 280bhp. Have to be careful with...