165000 miles.
4 previous owners.
Salut!
http://i266.photobucket.com/albums/ii245/pookiet5/P1010076.jpg
165000 miles.
4 previous owners.
Salut!
http://i266.photobucket.com/albums/ii245/pookiet5/P1010076.jpg
http://www.ferriday.co.uk/cnc/decompression_plates.shtml
Salut!
Pookie
Pedro. With that set-up I'm sure you could, but hardly standard is it?
Salut!
Pookie
Very impressed with that rear spoiler. I also would like to see photos of the build.
Salut!
Pookie
Copper grease will be fine.
Salut!
Pookie
Genuine volvo = Bosch.
Try your local motor factor but insist on bosch.
Salut!
Pookie
I'll be looking at one in the New Year.
Salut!
Pookie
Wurth plastic dye. The dog's b*****ks. Black or grey. Expensive but worth every penny. A picture is worth a thousand words.
Salut!
Pookie
...
http://i266.photobucket.com/albums/ii245/pookiet5/P1010076.jpg
Pookies daily driver, and he loves it!
www.davebarton.com
Salut!
Pookie
I'd go genuine Volvo. Speak to Rufe.
Salut!
Pookie
To be honest I'm not sure. I can't get any technical info. that deals with pressures in the A/C system only weights of refridgerent. Sorry. However as by passing the switch makes the compressor work...
I'll start again. The low pressure switch prevents the compressor from working if the system pressure is too low. So either the switch is faulty or the pressure is too low. To change the switch...
Check the air con low pressure switch at the back of the engine bay, just bridge it out and see what happens. Let us know what happens and I'll take you to the next stage if necessary.
Salut!
...
I use Wurth plastic dye and wouldn't use anything else. Pricey but works, 12 to 18 months and then needs refreshing.
Salut!
Pookie
On the dash top there is a clip that you haven't hooked in. Bin there, done that!
Salut!
Pookie
I've always used NGK Iridiums in my R and never had any problems.
Salut!
Pookie
No they aren't black, they're Jaguar Carlton Grey,which is the nearest match to the wheels on the car when I bought it. I much prefer the darker colour. Here's another photo. BTW I can think of two...
When you press and hold the pedal the second time does it creep to the floor? If not then you have air in the system somewhere.
Salut!
Pookie
The commonest symptom of master cyl. problems is pedal creep. Hold the brakes on lightly and if the pedal creeps to the floor- New cylinder req. This is assuming however that the rest of the...
Hi Abdul,
It's impossible to repair a porous wheel, but make sure that when you fit a tyre to the rim, that the tyre seat area is throughly cleaned , and use plenty of rim sealant.
Pookie
Volans for me .
But then again I'm biased.
Pookie
Lee
Try Andrew Page or Eurothingy for struts-they both do them.
Pookie
They look pretty much O.K. for the job.
Pookie
I have a wiring diagram for a 1996 850. Unfortunately my scanner isn't working so I can't upload it. However. The power for both front seat heater switches comes via. fuse 26. This 12v feed when...