Join Today
Tab Content
  • MoleT-5R's Avatar
    Wednesday 13th February 2019, 14:08
    Yep it really was a parts special, trying out a lot of the parts going on to the P2 V70R Awd and in my opinion the finest they made, it was just a...
    8 replies | 134 view(s)
  • MoleT-5R's Avatar
    Wednesday 13th February 2019, 13:27
    I'm not going to name anyone, but some good volvo guys have fallen foul with those individual gaskets, that's why many like the later v50 t5 item,...
    8 replies | 115 view(s)
  • MoleT-5R's Avatar
    Tuesday 12th February 2019, 17:29
    Well got a bit of time to take these, don't know how people can get them on wrong, but they have in the past, may be it's just because they are going...
    8 replies | 115 view(s)
  • MoleT-5R's Avatar
    Monday 11th February 2019, 22:19
    The correct way up to seal ...lol.... not much help I know, but I could tomorrow take a couple of shots to show the difference, as I will be in the...
    8 replies | 115 view(s)
  • MoleT-5R's Avatar
    Monday 11th February 2019, 21:57
    Wow a fuel pump change, that is not an easy undertaking on this model, unlike the fwd's. I'm doubting that this is the real issue, as the code po422...
    8 replies | 134 view(s)
  • LeeT5's Avatar
    Monday 11th February 2019, 21:04
    It means take the car to a gearbox specialist for a confirmed diagnosis and in the mean time, avoid wide open throttle and high load conditions or...
    4 replies | 71 view(s)
  • LeeT5's Avatar
    Monday 11th February 2019, 20:56
    1. Check the calipers are not slightly binding. 2. Propshaft CV's. 3. Driveshafts inners / outers excess play. 4. Wheel alignment can also cause...
    4 replies | 96 view(s)
  • MoleT-5R's Avatar
    Monday 11th February 2019, 11:45
    If it's been blowing a while then, I would look at replacing the gasket/gaskets (depending on whether you have the one piece item or the individual...
    8 replies | 115 view(s)
  • LeeT5's Avatar
    Monday 11th February 2019, 08:40
    Sounds to me like your auto box is slipping. Oh dear :(
    4 replies | 71 view(s)
  • LeeT5's Avatar
    Monday 11th February 2019, 08:37
    What makes you think the studs broken? They nearly always work loose, especially on cylinder 1 and 2. Just carefully tighten them back up, but...
    8 replies | 115 view(s)
  • LeeT5's Avatar
    Tuesday 5th February 2019, 04:42
    LeeT5 replied to a thread V70r in Phase 2 Models
    You'll need to with that mileage! Last recorded at 308,172 on 01/03/2018.
    2 replies | 161 view(s)
  • LeeT5's Avatar
    Tuesday 5th February 2019, 04:31
    Mmmm, incorrect FP would store a FP fault code anyway, so I assume this was ok? A blocked fuel filter would normally store a P0089 fault code and as...
    5 replies | 173 view(s)
  • LeeT5's Avatar
    Tuesday 5th February 2019, 04:03
    Hi Chris. The first place I would look is VIDA and any fault codes, especially in relation to CANbus issues with no comms for the ECM (Engine...
    5 replies | 173 view(s)
  • LeeT5's Avatar
    Sunday 3rd February 2019, 19:15
    They don't self heal, as you say, but the coil windings which are made of copper do get very hot. Consequently, the copper strands break. On rare...
    5 replies | 202 view(s)
  • MoleT-5R's Avatar
    Friday 1st February 2019, 12:03
    MoleT-5R replied to a thread Project 850 T5 AWD in Projects
    Thanks Rob, that's handy to know for when I require some fitting in the future.
    129 replies | 33040 view(s)
  • MoleT-5R's Avatar
    Wednesday 30th January 2019, 18:10
    nope...but I'm just starting a m66 awd conversion on our P1 Ph3 V70R awd, which will see it gain an extra pedal.... :)
    1 replies | 110 view(s)
  • LeeT5's Avatar
    Wednesday 30th January 2019, 16:09
    The copper coil winding inside the coil breaks / open circuit and you lose the spark. This usually occurs when hot and under load, but can also occur...
    5 replies | 202 view(s)
  • oblark's Avatar
    Saturday 26th January 2019, 21:29
    oblark replied to a thread Project 850 T5 AWD in Projects
    All I had to do was to file 2mm off of the two posts that the injector rail bolts too. Had a bit of a funny week with the car, after it had been...
    129 replies | 33040 view(s)
  • MoleT-5R's Avatar
    Monday 21st January 2019, 07:42
    MoleT-5R replied to a thread Project 850 T5 AWD in Projects
    is there much modification needed to fit the 550's Rob ?
    129 replies | 33040 view(s)
  • MoleT-5R's Avatar
    Monday 21st January 2019, 07:37
    Very nice Mike, looks like business is on the up and up, good word of mouth beats any advertising you can buy, Jag looks lovely but I'm still...
    16 replies | 910 view(s)
  • oblark's Avatar
    Sunday 20th January 2019, 20:29
    oblark replied to a thread Project 850 T5 AWD in Projects
    I did some 3rd gear pulls yesterday and found it has a little hiccup when coming on boost. I think it's down to the BTC table as I've set...
    129 replies | 33040 view(s)
No More Results
About stribo

Basic Information

About stribo
Location:
Mortimer
Interests:
cars,cars,cars, and PS4
Occupation:
Groundworker

Statistics


Total Posts
Total Posts
13,305
Posts Per Day
5.14
Albums
Total Albums
1
Total Photos
28
Total Thanks
Total Thanks
2,616
General Information
Last Activity
Sunday 6th January 2019 23:34
Join Date
Tuesday 17th January 2012
Referrals
1

20 Friends

  1. BIG G BIG G is offline

    Senior Member

    BIG G
  2. c70geoff c70geoff is offline

    Senior Member

    c70geoff
  3. c70jme c70jme is offline

    Junior Member

    c70jme
  4. Colesy Colesy is offline

    Junior Member

    Colesy
  5. craigieboy craigieboy is offline

    Member

    craigieboy
  6. hillsidesteve hillsidesteve is offline

    Senior Member

    hillsidesteve
  7. hrhvolvo hrhvolvo is offline

    Junior Member

    hrhvolvo
  8. iancho iancho is offline

    Senior Member

    • Send a message via AIM to iancho
    iancho
  9. JT JT is offline

    Senior Member

    JT
  10. LeeT5 LeeT5 is offline

    Senior Member

    LeeT5
Showing Friends 1 to 10 of 20
Page 1 of 2 12 LastLast

Thursday 1st May 2014

  • 22:15 - stribo changed their status to "Still more fettling needed, will it never end?"

Monday 10th March 2014

  • 23:54 - stribo changed their status to "Fettling isn't going well :("

Saturday 23rd November 2013

  • 17:56 - stribo changed their status to "Time for some fettling."

Sunday 7th July 2013

  • 22:54 - stribo changed their status to "I proved Frankie wrong, nuff said. ;)"

Sunday 16th June 2013

  • 19:59 - stribo changed their status to "If there's any butt kicking to be done, I'm the one doing it. :)"

Thursday 17th January 2013

  • 12:25 - stribo changed their status to "Mr Atacama"

Friday 28th December 2012

  • 22:40 - stribo changed their status to "chillin'"

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For stribo
View Complete Feedbacks for stribo
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0
ipv6 ready