stapos
Junior Member

forced it up on the drivers side, I'll try again next weekend and let you know the outcome, thanks once again, Stapos

Yeah managed to look at it, how did you get the dash out if you couldn't get the top off??..
You may have to remove the glove box to get access to the screws holding the top in place (can't remember it's been a while lol). Once you've unscrewed the glove box you'll just have to remove the hinges for the lid (these can be fiddly), just insert a small enough screw driver into where they go into the lid and they should pull out, after that the glove box just pulls out.

When you refit the top of the dash if you look at the edge where it's sticking up there is a clip, this needs to be slid into a hole on the side of the dash. Best to remove the dashtop, sit it just off the dash and then slide it into place making sure you push the clip in as it goes...

Hope this helps..