Join Today
Tab Content
  • htomi's Avatar
    Sunday 13th August 2017, 11:47
    htomi replied to a thread htomi's thread in Phase 2 Models
    Regarding the heat concern what Lee mentioned above. After a 45 mins spirited drive, lifted the trunk floor cover and touched the PEM with my hands,...
    37 replies | 2439 view(s)
  • petrolh34d's Avatar
    Thursday 10th August 2017, 10:49
    Yes, those are the ones Jon. The large 52.5 offset meant that they wouldn't go on without spacers though, as they hitting the shocks. I'm...
    13 replies | 363 view(s)
  • htomi's Avatar
    Thursday 10th August 2017, 08:36
    htomi replied to a thread Petrol fumes in Phase 2 Models
    I'd also pull up rear seats and take off the both pump and sender unit covers to see if there is any petrol on top of the units. Takes literally 2...
    8 replies | 241 view(s)
  • petrolh34d's Avatar
    Tuesday 8th August 2017, 21:52
    They look great on it! My Jag wheels were a right nightmare to get on. Did you have to use spacers?
    13 replies | 363 view(s)
  • petrolh34d's Avatar
    Tuesday 8th August 2017, 21:43
    petrolh34d replied to a thread Project 850 T5 AWD in Projects
    Great work!
    52 replies | 6653 view(s)
  • htomi's Avatar
    Tuesday 8th August 2017, 12:11
    htomi replied to a thread htomi's thread in Phase 2 Models
    Yes, the heat is a concern too. However: 1. Based on the TNN TNN 23-32-2008-04-30 mentioned above, the PEM has been relocated at the right end side...
    37 replies | 2439 view(s)
  • htomi's Avatar
    Monday 7th August 2017, 20:13
    htomi replied to a thread htomi's thread in Phase 2 Models
    Yeah, the devil plays on his instrument to push the black magic into these modern cars....
    37 replies | 2439 view(s)
  • htomi's Avatar
    Monday 7th August 2017, 20:00
    htomi replied to a thread htomi's thread in Phase 2 Models
    and .... PEM relocated in the trunk. Used the original cable. Jacked up the car, followed the cable from the PEM. Its held by 5 clips. Used a...
    37 replies | 2439 view(s)
  • htomi's Avatar
    Saturday 5th August 2017, 18:05
    htomi replied to a thread htomi's thread in Phase 2 Models
    Update. The Skandix pump failed. Seems, one of the pump motor is shot. Old pump re-installed. PEM ended up again under the car due to the...
    37 replies | 2439 view(s)
  • htomi's Avatar
    Friday 4th August 2017, 20:00
    I have the forge cbv, however my car hasn't been tuned. It is bolt on. However its a pain in the hole job to install. As you're planning to map your...
    17 replies | 302 view(s)
  • htomi's Avatar
    Monday 31st July 2017, 13:13
    htomi replied to a thread htomi's thread in Phase 2 Models
    Update. Step 1 completed. Old PEM removed and opened. There was some type of white dust covering the board (similar to an oxidation what a leaking...
    37 replies | 2439 view(s)
  • htomi's Avatar
    Saturday 29th July 2017, 12:37
    htomi replied to a thread htomi's thread in Phase 2 Models
    Wednesday, my R left me at the side of the road. It suddenly stalled and lost al power, then it seemed to misfire for 10 more meters and finally...
    37 replies | 2439 view(s)
  • htomi's Avatar
    Saturday 29th July 2017, 12:18
    htomi replied to a thread LeeT5's V70R Project in Phase 2 Models
    Nice! :B_thumb::B_thumb::B_thumb:
    506 replies | 71953 view(s)
  • petrolh34d's Avatar
    Tuesday 25th July 2017, 16:51
    petrolh34d replied to a thread 1998 V70 2.5 TDi (AEL) in Projects
    Not a performance mod, but I was constantly getting it in the ear from my fiance, because she was constantly getting it in the ear from the straight...
    17 replies | 2232 view(s)
  • petrolh34d's Avatar
    Tuesday 25th July 2017, 16:26
    Just checked my tyres again to make sure. They are actually 225 40 18 :confused: So yeah, something narrower should definitely help to prevent rub.
    6 replies | 214 view(s)
  • htomi's Avatar
    Monday 24th July 2017, 09:49
    htomi replied to a thread Donnas s60r in Phase 2 Models
    :B_thumb::B_thumb::B_thumb:
    126 replies | 5973 view(s)
  • petrolh34d's Avatar
    Sunday 23rd July 2017, 16:12
    205 45 18
    6 replies | 214 view(s)
  • petrolh34d's Avatar
    Sunday 23rd July 2017, 15:15
    I've run 8 x 18 on two consecutive V70 phase 1's. Of course it's mostly down to offset (can't remember exactly what way mine are sitting now) but...
    6 replies | 214 view(s)
  • petrolh34d's Avatar
    Thursday 20th July 2017, 16:43
    petrolh34d V70 2.5 TDi 1998 326,607 miles (now scrapped) SLRmocoV70 2.4 140SE 2003 313,000 miles Paul V70 2.0 256,000 miles (what year?) James...
    177 replies | 14463 view(s)
No More Results
About htomi

Basic Information

About htomi
Location:
Cork, Ireland

Signature




2004 Volvo V70R GT/Titanium Gray/Gobi do88 Intake, do88 Lower Intercooler pipe, Forge CBV with green spring, 17'Pegasus, 235/45/17 Goodyear Eagle F1 AS3

Statistics


Total Posts
Total Posts
375
Posts Per Day
0.60
Albums
Total Albums
1
Total Photos
9
Total Thanks
Total Thanks
121
General Information
Last Activity
Yesterday 19:06
Join Date
Monday 7th December 2015
Referrals
0

1 Friend

  1. petrolh34d petrolh34d is offline

    Senior Member

    petrolh34d
Showing Friends 1 to 1 of 1
No results to display...
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For htomi
View Complete Feedbacks for htomi
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0
ipv6 ready