View Full Version : Brembo's & DS pads
Johnny
Tuesday 14th March 2006, 15:51
Right - im going to fit these tonight and I cant wait.
The Brembo Discs look well made and have been finished off quite nicely.
The pads however just look damn feirce! I cant seem to find out what the composite is made from but they seem to have a copper sinter in them.
I will let you know how the fitting goes. Is there anything I should be looking out for / common issues?
John.
Wobbly Dave
Tuesday 14th March 2006, 16:05
I have a how 2 with pictures in the knowledge base board...
http://www.vpcuk.org/forums/showthread.php?t=6695
and how to stop them squeaking (if you find they do)
http://www.volvot5.co.uk/forums/showthread.php?t=1277
Do at least 2 full 1/2 heat cycles on the brakes to bed them in properly
Johnny
Tuesday 14th March 2006, 16:24
Thanks Wobbly Dave!
Hopefully ill be able to stop properly soon!
Babybadger
Tuesday 14th March 2006, 17:13
I have a how 2 with pictures in the knowledge base board...
http://www.vpcuk.org/forums/showthread.php?t=6695
and how to stop them squeaking (if you find they do)
http://www.volvot5.co.uk/forums/showthread.php?t=1277
Do at least 2 full 1/2 heat cycles on the brakes to bed them in properly
I like the squeaking. I just put the music up and roll the car on the brakes near bus stops with lots of people........I can't hear it.......... :dgrin: and it sounds great :tank:
What do you mean by 'Do at least 2 full 1/2 heat cycles on the brakes to bed them in properly'
Jod T5
Tuesday 14th March 2006, 17:17
how much were the pads, from vt?? :B_steerin
Wobbly Dave
Wednesday 15th March 2006, 09:56
...What do you mean by 'Do at least 2 full 1/2 heat cycles on the brakes to bed them in properly'Positive braking with firm-ish pressure - to allow the brakes to get upto 1/2 full temp. Let them cool off again and repeat. Just to make sure you dont warp anything and the pads bed in properly.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.