Hub Adapters

[Ford T5]

Hi, My aim is to fit a set of Serapis alloy from a V50 on to a 850. This requires a 10mm spacer each side to allow for the difference in offset. The 850 have counter bore of 65.1mm and the V50 one of 63.3mm. I have looked on line and so far not come across an off the shelf hub adapter. Do they exist?

[claymore]

you need to have the center bores machined out.

[sye73]

+1
And finding someone to do this can be a challenge! Not difficult to do in principle, but you need the right tools

[claymore]

I used a flap wheel on the end of a drill to do mine :)

[sye73]

blimey!