View Full Version : Hub Adapters
Ford T5
Tuesday 26th July 2016, 18:08
Hi, My aim is to fit a set of Serapis alloy from a V50 on to a 850. This requires a 10mm spacer each side to allow for the difference in offset. The 850 have counter bore of 65.1mm and the V50 one of 63.3mm. I have looked on line and so far not come across an off the shelf hub adapter. Do they exist?
claymore
Tuesday 26th July 2016, 18:10
you need to have the center bores machined out.
sye73
Tuesday 26th July 2016, 20:00
+1
And finding someone to do this can be a challenge! Not difficult to do in principle, but you need the right tools
claymore
Tuesday 26th July 2016, 20:08
I used a flap wheel on the end of a drill to do mine :)
sye73
Tuesday 26th July 2016, 22:35
blimey!
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.