Feed for AFR gauge

[jimka]

Hi chaps,

I'm trying to find the best place to tap in a feed for my Innovate MTX-L AFR gauge.

I thought about the 12v cig lighter but was worried about the draw required to heat the sensor (and I'm already powering a Dash-Cam). I also noted that fuse 18 in engine bay (key warning chime) has a 10amp fuse so could wire in a spur off this if powered on accessory II.

Any other thoughts?

Car is a 98' V70R.

Ta

Jimka

[Dangerous Dave]

I have wired my wideband controller into fuse number 3 on my 850 (immobiliser or fuel pump, something like that) as that feed is on at ignition switch stage 2 and 3 (drive and start, doesn't get turned off when starting) plus it is a hefty feed from the battery through a relay (according to the volvo wiring diagram).

On my 850 fuses 2, 3 and 4 are on the same feed, it's best to check out your wiring diagrams to make sure you're getting the right feed.

Hope this helps