BobbysleeperV70
Monday 15th December 2014, 18:05
Ok so after a long laborious engine change the 70 is running again.
I have a fault code that has flashed up
Can't remember the code but the message that came with the code was as follows:
Boost pressure sensor- permenant- signal too high.
Anyone have any ideas?
It's running a 19t rica upgrade and was running spot on before the engine change...
I'm using the BPS from the new engine as I can't find my original... Would the sensor be different for a 19t upgrade?
Anyone have any ideas how to sort this?
Kinda desperate now as it's running limp home low boost mode and raping fuel and I have now uninsured my Audi :/
Cheers..
Bobby
I have a fault code that has flashed up
Can't remember the code but the message that came with the code was as follows:
Boost pressure sensor- permenant- signal too high.
Anyone have any ideas?
It's running a 19t rica upgrade and was running spot on before the engine change...
I'm using the BPS from the new engine as I can't find my original... Would the sensor be different for a 19t upgrade?
Anyone have any ideas how to sort this?
Kinda desperate now as it's running limp home low boost mode and raping fuel and I have now uninsured my Audi :/
Cheers..
Bobby