gazjacko
Sunday 16th October 2005, 00:21
Am I missing something? All the threads I've seen (volvospeed / Ozbrick etc) state that when removing the front calipers you need a Hex bit (7mm).
Today I just undid the carrier bolts took the whole lot off and then pulled the caliper and carrier apart. Cleaned everything off and re-assembled then slipped the whole assembly back over the disc and replaced the bolts.
My problem is with a lifted seal causing corrosion to the piston so it's only a temp replacement 'til I get a new caliper.
Today I just undid the carrier bolts took the whole lot off and then pulled the caliper and carrier apart. Cleaned everything off and re-assembled then slipped the whole assembly back over the disc and replaced the bolts.
My problem is with a lifted seal causing corrosion to the piston so it's only a temp replacement 'til I get a new caliper.