View Full Version : compressor wheel nut torque setting
theflyingbrick
Sunday 17th March 2013, 16:29
Does any body know how tight the nut is supposed to be that holds the compressor wheel on?? Its a 19t if that makes a difference??
Yosser
Sunday 17th March 2013, 16:49
It's 40 inch pounds or 4.5 NM. You'll need a torque screwdriver, or similar, to go down to such a low figure.
theflyingbrick
Sunday 17th March 2013, 16:55
It's 40 inch pounds or 4.5 NM. You'll need a torque screwdriver, or similar, to go down to such a low figure.
top man thankyou very muchly sir ;) i never rebuilt the turbo and its already on the car but it feels too tight if that makes sense,and i just remember turning the compressor wheel and thinking it was a tad to tight so im gonna whip it off and check it over.......best get my brolly out the boot lol
Redbrick
Monday 18th March 2013, 14:55
It's 40 inch pounds or 4.5 NM. You'll need a torque screwdriver, or similar, to go down to such a low figure.
+1
Be very careful. I've read a thread by 'dooby' where he explains the process and the pitfalls.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.